Abstract:Understanding the distribution of cutting force provides a foundation for the design and optimization of cutterhead layout. The simulation of rotary cutting with a large cutting radius remains a challenge for laboratory tests. In this study, taking the driving condition of the Mawan Tunnel located in the Guangdong-Hong Kong-Macao Greater Bay Area as a case study, a full-scale rotary cutting platform with large cutting radius was used to investigate the rock-breaking effects. Rotary cutting with cutting depths of 1–8 mm and cutting radii of 200–1400 mm were carried out on the granite testing platform using a 19-in disc cutter. The normal force, rolling force, and side force during the cutting process were systematically monitored. Moreover, the time–frequency characteristics of the rock breaking process and the effects of cutting depth, cutting radius and stress state on the average and peak loads were investigated. The results show that the average normal force and rolling force increased with increasing cutting depth, while the side force was less affected by cutting depth through the Boltzman model analysis. The average normal force and rolling force were not significantly affected by the cutting radius, but the average side force decreased as a power function with increasing cutting radius, and showed a stable side force when the installation radius exceeded 1000 mm. The dominant frequency of the cutting force was 0–1.2 Hz, exhibiting notable low-frequency characteristics. Additionally, the ratio of peak to average (RPA) with respect to triaxial cutting force demonstrated an increase with the growth of cutting depth, while RPA in terms of side force exhibited a corresponding growth with the increasing cutting radius. In particular, the cutting force characteristics of the cutterhead obtained in this study can inform the layout of disc cutters and real-life TBM operations, thereby avoiding severe overloading of internal disc cutters.

Investigation of the Influence of Cutter Geometry on the Cutting Forces in Soft–Hard Composite Ground by Tunnel Boring Machine Cutters

Research on Rock-Breaking Characteristics of Cutters and Matching of Cutter Spacing and Penetration for Tunnel Boring Machine

Experimental and numerical investigations on the force characteristics of cutter in different regions of the TBM cutterhead

Study of Rock-Cutting Process by Disc Cutters in Mixed Ground based on Three-dimensional Particle Flow Model

Study of the cutter-rock interaction mechanism during TBM tunnelling in mudstone: insight from DEM simulations of rotatory cutting tests

Comparative Study of the Rock-breaking Mechanism of a Disc Cutter and Wedge Tooth Cutter by Discrete Element Modelling

Full-scale Test of Disc Cutter Rotary Cutting in TBM Tunnelling: a Case Study of Mawan Granite in Shenzhen, China

Experimental Investigation on the Influence Factors on TBM Cutter Wear Based on Composite Abrasion Test

Experimental Study on Partial Wear of TBM Disc Cutter

Investigation on rock breaking and optimum spacing of TBM cutters under confining stress using a continuum-discontinuum method

Numerical study on the rock breaking mechanism of high-pressure water jet-assisted TBM digging technique based on 2D-DEM modelling

Penetration behaviour of TBM disc cutter assisted by vertical precutting free surfaces at various depths and confining pressures

RESEARCH ON ROCK DYNAMIC FRAGMENTATION CHARACTERISTICS BY TBM CUTTERS AND CUTTER SPACING OPTIMIZATION

Physical and Numerical Studies of Rock Fragmentation Subject to Wedge Cutter Indentation in the Mixed Ground

Influence of Penetration on the Rock-Breaking Efficiency of a TBM Cutter

Numerical Simulation Research on Rock Breakage Mechanism and Influence TBM Cutters

Analysis on the Rock–Cutter Interaction Mechanism During the TBM Tunneling Process

Evaluation of TBM Cutter Wear in Granite and Developing a Cutter Life Prediction Model for Face Cutters Based on Field Data: A Case Study

Study On Rock-Breaking Simulation And Experiment Of Double Disc Cutter Of Tbm

Simulation of indentation behavior of TBM disc cutter and failure mechanism of hard rock assisted by hydraulic precutting kerfs

Full-scale linear cutting tests to study the influence of pre-groove depth on rock-cutting performance by TBM disc cutter