Abstract:Background: Rehabilitation of partially or totally edentulous posterior mandible with implant-supported prosthesis has become a common practice in the last few decades, with reliable long-term results. The use of miniscrews and miniplates have been reported to increase the risk of fracture of the osteotomy segments. The purpose of this case series was to use an inlay technique, without the use of miniscrews and miniplates for stabilization of the transported bone fragments. Materials and methods: Nine consecutive patients (six men and three women) aged between 26 and 51 years (mean 44 years) were enrolled in this study. A horizontal osteotomy was performed 2-3 mm above the mandibular canal, and two oblique cuts were made using a piezosurgery device. The final phase of the osteotomy was performed with chisels. The osteotomized segment was then raised in the coronal direction, sparing the lingual periosteum. Two miniblocks of xenograft without miniscrews and miniplates were inserted mesially and distally between the cranial osteotomized segment and the mandibular basal bone. The residual space was filled with particles of cortico-cancellous porcine bone. Four months after surgery, a panoramic X-ray was taken before implant insertion. A bone trephine with an internal diameter of 2 mm was used as the second dental drill to take a bone core biopsy during preparation of the #35 and #37 or #45 and #47 implant sites. Results: The postoperative course was uneventful in seven of the nine patients. No dehiscence of the mucosa was observed at the marginal ridge of the mobilized fragment. Newly formed bone was present near the osteotomized segments, and was observed in the bottom half of the specimens and was identified by its higher affinity toward the staining. Newly formed bone was observed to be in close contact with the particles of biomaterials. No gaps or connective tissue were present at the bone-biomaterial interface. Histomorphometry demonstrated that 44±2.1% of the specimens was composed by newly formed bone, 18±0.8% by marrow spaces, and 33±2.4% by the residual grafted biomaterial. Conclusion: The rigidity of the equine collagenated block allowed to eliminate the use of miniscrews and miniplates and simplified the technique. Moreover, the rigidity of the block allowed maintenance of the space.

Subperiosteal Ridge Augmentation Technique Utilizing Sticky Bone: A Case Series

Tunnel Technique with a Subperiosteal Bag for Ridge Augmentation: A Case Series

Horizontal ridge augmentation with a resorbable membrane and particulated autogenous bone with or without anorganic bovine bone-derived mineral: a prospective case series in 22 patients

Alveolar ridge augmentation using autogenous bone graft and platelet-rich fibrin to facilitate implant placement

Technical Considerations and Case Series Reports

A modified crestal ridge expansion technique for immediate placement of implants: a report of three cases

Direct Sinus Augmentation Procedure for Rehabilitation of Severely Atrophic Posterior Maxilla with Sticky Bone – A Case Report

Vertical ridge augmentation of atrophic posterior mandible using an inlay technique with a xenograft without miniscrews and miniplates: case series

Histologic and Clinical Evaluation of Ridge Augmentation of Extraction Sockets with Severe Bone Defects: A Clinical Prospective Study

EVALUATION OF ONE-STAGE INVERTED U-SHAPED RIDGE SPLITTING AND CONCURRENT IMPLANT PLACEMENT IN ANTERIOR MAXILLARY UNDERCUT DEFECT(A CLINICAL TRIAL)

A new technique of alveolar bone augmentation: "Pack into Bone". A retrospective case-series study

Versatility of Vertical Distraction Osteogenesis and Sticky Bone in Three-Dimensional Augmentation for Atrophic Alveolar Ridge

Horizontal ridge augmentation in the maxillary aesthetic region using the autogenous circular cortical‐lamina anchoring technique: A case series study

A novel approach to treat peri-implantitis using sticky bone

Guided Bone Regeneration with Concentrated Growth Factor Enriched Bone Graft Matrix (Sticky Bone) vs. Bone-Shell Technique in Horizontal Ridge Augmentation: A Retrospective Study

A three-in-one alveolar process reconstruction protocol for maxillary molar sites with severe residual bone height deficiency: A proof-of-concept pilot study

Volumetric changes in edentulous alveolar ridge sites utilizing guided bone regeneration and a custom titanium ridge augmentation matrix (CTRAM): a case series study

Mandibular Ridge Expansion Using a Horizontal Bone-Splitting Technique and Synthetic Bone Substitute: An Alternative to Bone Block Grafting?

Minimally Traumatic Alveolar Ridge Augmentation with a Tunnel Injectable Thermo-Sensitive Alginate Scaffold

Immediate single-tooth replacement with acellular dermal matrix allogeneic bone and ossifying collagen scaffold: A case series

Ridge preservation combined with open barrier membrane technique in case of post-extractive oro-antral communication: a case series retrospective study