Abstract:In Part I of this study, the benchmark test and signal calibration of contact and non-contact measurement to quantitatively assess the variation and difference between contact and non-contact measurements. Based on the research findings of Part I, non-contact multi-channel analysis of surface waves (MASW) technique and novel impact acoustic vibration method are proposed in Part II of this study. Aided by scanning Doppler laser vibrometer and a combination of conventional and high-frequency microphones, the feasibility of non-contact non-destructive test (NDT) for SCCS is validated using experimental measurements on steel plate-bonded reinforced concrete (RC) cube with preset interfacial debondings in various dimensions. Since the steel plate at the debonding regions loses the constraint of concrete core, its vibration mode changes obviously. Experimental observations indicate that the accurate location of interfacial debonding can be accurately recognized by non-contact stress wave measurement. Besides, the amplitude of impact-acoustic vibration signal increases remarkably while interfacial debonding occurs, and its frequency spectrum is obviously different from that of healthy regions. Contact NDT techniques, including the impact-response test and impact-transmission test, are also performed for further comparison. Research findings show that the non-contact vibration measurement exhibits high efficiency. More importantly, it can eliminate the test error induced by the additional mass and sensor sticking process. Difference in signal characteristics and imaging precision of contact and non-contact measurement is discussed in detail. In contrast, damage nephogram resolution based on signal amplitude is higher than that of the dominant frequency. Combined with Part Ⅰ of this study, which focuses on benchmark test and signal calibration, the research findings in this study can lay a solid foundation for improving the detection accuracy of interfacial debondings in SCCS using non-contact NDT techniques.

Numerical and experimental investigation on debonding detection in honeycomb sandwich using air-coupled local defect resonance and coda wave analysis

A novel nondestructive testing method for honeycomb structure using acoustic band gap

Debonding detection of honeycomb sandwich structures using frequency response functions

Torsional Guided Wave-Based Debonding Detection in Honeycomb Sandwich Beams

Application of Lamb wave and its coda waves to disbond detection in an aeronautical honeycomb composite sandwich

An Algorithm Based on Logarithm of Wavenumber Amplitude for Detection of Delamination in Carbon Fiber Composite

An Improved Damage Index for Nondestructive Evaluation of a Disbond in Honeycomb Sandwich Structure Using Guided Waves

Digital twin method for predicting the critical load of debonding damage in honeycomb sandwich structures based on distributed optical fiber sensor and Dynamic Bayesian Network

Nondestructive Inspection and Quantification of Select Interface Defects in Honeycomb Sandwich Panels

Interfacial Debonding Detection for Steel-Concrete Composite Structures Part II: Scanning Doppler Laser-Based MASW and Microphone Combination-Based Impact-Acoustic Vibration

LFM-Chirp-Square pulse-compression thermography for debonding defects detection in honeycomb sandwich composites based on THD-processing technique

Investigation of failure behavior in honeycomb sandwich panel containing interfacial debonding

Nonlinear harmonic wave-guided interfacial debonding identification in RC beams

Damage Imaging Identification of Honeycomb Sandwich Structures Based on Lamb Waves

Damage Localization in Composite Lattice Truss Core Sandwich Structures Based on Vibration Characteristics

Research on pulse infrared thermal wave detection technology for honeycomb sandwich structure defects

Vibration-Based In-Situ Detection and Quantification of Delamination in Composite Plates

Near-field Microwave Identification and Quantitative Evaluation of Liquid Ingress in Honeycomb Sandwich Structures

Energy Transfer Efficiency Based Nonlinear Ultrasonic Testing Technique for Debonding Defects of Aluminum Alloy Foam Sandwich Panels

Non‐destructive testing method of micro‐debonding defects in composite insulation based on high power ultrasonic

Damage Detection Method Based on Lamb Waves for Stiffened Composite Panels