Abstract:Achieving a viable process for three-dimensional (3D) printing of ceramics is a sought-after goal in a wide range of fields including electronics and sensors for harsh environments, microelectromechanical devices, energy storage materials, and structural materials, among others. Low laser absorption of ceramic powders renders available additive manufacturing (AM) technologies for metals not suitable for ceramics. Polymer solutions that can be converted to ceramics (preceramic polymers) offer a unique opportunity to 3D-print ceramics; however, due to the low viscosity of these polymers, so far, their 3D printing has only been possible by combining them with specialized light-sensitive agents and subsequently cross-linking them layer by layer by rastering an optical beam. The slow rate, lack of scalability to large specimens, and specialized chemistry requirements of this optical process are fundamental limitations. Here, we demonstrate 3D printing of ceramics enabled by dispensing the preceramic polymer at the tip of a moving nozzle into a gel that can reversibly switch between fluid and solid states, and subsequently thermally cross-linking the entire printed part "at-once" while still inside the same gel. The solid gel, which is composed of mineral oil and silica nanoparticles, converts to fluid at the tip of the moving nozzle, allows the polymer solution to be dispensed, and quickly returns to a solid state to maintain the geometry of the printed polymer both during printing and the subsequent high-temperature (160 °C) cross-linking. We retrieve the cross-linked part from the gel and convert it to ceramic by high-temperature pyrolysis. This scalable process opens up new opportunities for low-cost and high-speed production of complex three-dimensional ceramic parts and will be widely used for high temperature and corrosive environment applications, including electronics and sensors, microelectromechanical systems, energy and structural applications.

Three-Dimensional Printing of Yttrium Oxide Transparent Ceramics via Direct Ink Writing

3D Printing of Infrared Transparent Ceramics via Material Extrusion

Fabrication of highly transparent yttria by DLP-based additive manufacturing

3D Printing of Transparent Spinel Ceramics with Transmittance Approaching the Theoretical Limit

3D printing of ceramics with controllable green‐body configuration assisted by the polyvinyl alcohol‐based physical gels

Fabrication of YAG ceramic tube by UV-assisted direct ink writing

Direct Ink Writing of Special-Shaped Structures Based on Tio2 Inks

POLYMER-DERIVED SIC CERAMIC WITH TRIPLY PERIOD MINIMAL SURFACE STRUCTURE FABRICATION THROUGH DIGITAL LIGHT PROCESSING

Direct ink writing of aluminum-phosphate-bonded Al2O3 ceramic with ultra-low dimensional shrinkage

3D printing of unsupported multi-scale and large-span ceramic via near-infrared assisted direct ink writing

Reinforcement effect in printing precision and sintering performance for liquid crystal display stereolithography additive manufacturing of alumina ceramics

Three-Dimensional Printing of Ceramics through "Carving" a Gel and "Filling in" the Precursor Polymer

Preparation and stereolithography 3D printing of ultralight and ultrastrong ZrOC porous ceramics

Achieving fabrication of highly transparent Y 2 O 3 ceramics via air pre‐sintering by deionization treatment of suspension

Effect of debinding and sintering profile on the optical properties of DLP-3D printed YAG transparent ceramic

3D printing of high solid Al2O3 ceramics based on green and renewable photosensitive resin with low viscosity and low shrinkage

Ceramic 3D Printing via Dye-Sensitized Photopolymerization Under Green LED

4D printing of ceramic structures

Digital light processing 3D printing of ceramic materials: a review on basic concept, challenges, and applications

Rheology and Printability of a Porcelain Clay Paste for DIW 3D Printing of Ceramics with Complex Geometric Structures

Fabrication and characterisation of ceramics via low-cost DLP 3D printing