Abstract:In a previous work, an ink based on a preceramic polymer, SiC fillers, and chopped carbon fibers was proposed for the production of Ceramic Matrix Composite (CMC) structures by Direct Ink Writing (DIW) and subsequent pyrolysis. Thanks to the shear stresses generated at the nozzle tip during extrusion, carbon fibers can be aligned along the printing direction. Fumed silica was added to the ink in order to enhance its rheological properties; however, the printed structures still showed some deformation in the Z direction. In this work, a second ink was successfully developed to limit deformation and at the same time avoid the addition of fumed silica, which limited the potential temperature of application of the composites. Instead, the positive role of the preceramic polymer on the ink rheology was exploited by increasing its concentration in the ink. Rheological characterization carried out on both inks confirmed that they possessed Bingham shear thinning behavior and fast viscosity recovery. Single filaments with different diameters (~310 µm and ~460 µm) were produced with the latter ink by DIW and subsequent pyrolysis. Tested under a four-point flexural test, the filaments showed a mean flexural strength above 30 MPa, graceful failure, and fiber pull-out. The results of this work suggest that CMC components can effectively be fabricated via DIW of a preceramic ink with embedded short fibers; the preceramic polymer is able to provide the desired rheology for the process and to develop a dense matrix capable of incorporating both fibers and ceramic particles, whereas the fibers addition contributes to an increase of the fracture toughness of the material and to the development of a graceful failure mode.

Direct Ink Writing of Special-Shaped Structures Based on Tio2 Inks

Direct-write Assembly of Ceramic Three-dimensional Structures Based on Photosensitive Inks

Direct Write Printing of Three-dimensional Photocatalytic TiO2 Structures

Direct ink writing:A novel avenue for engineering micro-/nanoscale 3D structures

UV-assisted direct ink writing of Si3N4/SiC preceramic polymer suspensions

Direct-ink-writing (DIW) 3D printing functional composite materials based on supra-molecular interaction

Direct Write Assembly of 3-Dimensional Structures with Aqueous-Based Piezoelectric Inks

Direct ink writing of 3D piezoelectric ceramics with complex unsupported structures

Three-Dimensional Printing of Yttrium Oxide Transparent Ceramics via Direct Ink Writing

Preliminary 3D Printing of Large Inclined-Shaped Alumina Ceramic Parts by Direct Ink Writing

Optimization and Characterization of Preceramic Inks for Direct Ink Writing of Ceramic Matrix Composite Structures

Recent progress of alumina ceramics by direct ink writing: Ink design, printing and post-processing

Direct Ink Writing of Mineral Materials: A review

Direct Ink Writing of 3D Cavities for Direct Plated Copper Ceramic Substrates with Kaolin Suspensions

Direct ink writing of pure pdms for soft 3d microstructures and tactile sensors

Recent Development and Applications of Advanced Materials via Direct Ink Writing

Direct 4D printing of gradient structure of ceramics

3D printing of unsupported multi-scale and large-span ceramic via near-infrared assisted direct ink writing

Fabrication of 3D Structures Via Direct Ink Writing of Kaolin/graphene Oxide Composite Suspensions at Ambient Temperature

Direct Ink Writing of Continuous SiO 2 Fiber Reinforced Wave-Transparent Ceramics