Abstract:Silicon has emerged as a highly promising anode material for lithium-ion batteries (LIBs) owing to its high specific capacity and low voltage. However, previous research on silicon-based anodes has not adequately addressed inherent issues, leading to limited commercial applications on a large scale. Therefore, further scientific investigation is necessary to uncover the lithiation/delithiation process in silicon materials and understand the influence of electrode potential and charge state on the kinetic process during charge and discharge. This understanding will be instrumental in gradually enhancing the performance of silicon materials. Herein, amorphous silicon films were prepared for LIB anodes using the magnetron sputtering method. Molecular dynamics simulations were conducted to investigate the microstructure and volumetric changes of the sputtered amorphous silicon anode during the lithiation and delithiation processes. Additionally, electrochemical characterization techniques such as a galvanostatic intermittent titration technique, electrochemical impedance spectroscopy, and galvanostatic charge–discharge test were employed to explore the electrochemical properties of silicon electrodes. Electrochemical analysis techniques, such as the differential capacity method and distribution of relaxation times, were also used to investigate the deterioration mechanisms of the electrochemical and conversion properties of amorphous silicon anodes. Results revealed that the lithium-ion content in Li x Si, determined through the set cutoff voltage during charge/discharge cycling, considerably affected the volume change of the silicon anode and the composition and integrity of the solid electrolyte interface after cycling. The optimum discharge cutoff voltage was found to be 0.08 V for the amorphous silicon electrode, leading to an optimum cycle life with a capacity retention of 87.17% after 100 cycles.

Lithiation Depth Regulation of Silicon Anodes toward Excellent Stability

Anionic Aggregates Induced Interphase Chemistry Regulation Toward Wide-Temperature Silicon-Based Batteries

Over‐Lithiation Regulation of Silicon‐Based Anodes for High‐Energy Lithium‐Ion batteries

Regulating Lithium Transfer Pathway to Avoid Capacity Fading of Nano Si Through Sub‐Nano Scale Interfused Siox/C Coating

The Solid Electrolyte Interphase on Silicon Electrodes Boosts the Stability of Lithium-Ion Batteries

Tailoring Stress and Ion-Transport Kinetics Via a Molecular Layer Deposition-Induced Artificial Solid Electrolyte Interphase for Durable Silicon Composite Anodes

Tailoring chemical composition of solid electrolyte interphase by selective dissolution for long-life micron-sized silicon anode

Lifetime Optimization of Amorphous Silicon Thin-Film Anodes for Lithium-Ion Batteries

Hollow Structured Silicon Anodes with Stabilized Solid Electrolyte Interphase Film for Lithium-Ion Batteries

Dynamic Mechanical Equilibrium of Silicon Anodes for Lithium-ion Batteries Enabled by Surface Hydroxyl-Rich Bonding

Suppressing Continuous Volume Expansion of Si Nanoparticles by an Artificial Solid Electrolyte Interphase for High-Performance Lithium-Ion Batteries

Enabling robust structural and interfacial stability of micron-Si anode toward high-performance liquid and solid-state lithium-ion batteries

Incorporation of lithium oxide into silicon anode via magnetron co-sputtering to optimize structural stability and cycling performance

Structural control and optimization schemes of silicon‐based anode materials

Trifluoropropylene Carbonate‐Driven Interface Regulation Enabling Greatly Enhanced Lithium Storage Durability of Silicon‐Based Anodes

Constructing a Stable Integrated Silicon Electrode with Efficient Lithium Storage Performance through Multidimensional Structural Design

In Situ Constructing of Rigid‐Soft Coupling Solid–Electrolyte Interphase on Silicon Electrode toward High‐Performance Lithium Ion Batteries

Rectifying Solid Electrolyte Interphase Structure for Stable Multi-Dimensional Silicon Anodes

Modulating porous silicon-carbon anode stability: Carbon/silicon carbide semipermeable layer mitigates silicon-fluorine reaction and enhances lithium-ion transport

Electrolyte Design Enabling a High‐Safety and High‐Performance Si Anode with a Tailored Electrode–Electrolyte Interphase

Enhanced Cycleability of Micron‐Size Silicon Anode by In Situ Polymerized Polymer Electrolyte