Abstract:The purpose of this study was to explore the influence and action mechanism of the stress amplitude on the evolution of the deformation behavior of sandstones during multilevel triaxial cyclic loading and unloading (CLU) under varying lower limits of stress (VLLS). To realize this purpose, a conventional triaxial compression test under a confining pressure of 5 MPa and multilevel triaxial CLU tests under VLLS and stress amplitudes of 5, 10, and 15 MPa were independently carried out. By summarizing and analyzing the change patterns of the deformation parameters of sandstones under the different stress amplitudes, the influence law and potential action mechanism of the stress amplitude on sandstones were illustrated. The test results indicated that the increase in stress amplitude provided more opportunity for grain slippage and crack formation in sandstones, causing further softening. As a result, the ratio of the stress at the point when the bearing capacity of the tested sandstones was lost at the postpeak stage to the peak stress decreased, and the elastic modulus decreased while the Poisson's ratio increased. Based on an analysis of the evolution trend of the incremental irreversible strain, the aforementioned phenomena occurred because the change curve of the incremental irreversible strain gradually steepened with increasing stress amplitude, transitioning from a horizontal linear curve to a U-shaped curve. However, during the observed volumetric strain change, stress amplitude increase caused a reduction in cohesion in the sandstones, thus shortening the transition period from expansion to contraction. The sandstones were directly damaged without a transition period when the stress amplitude reached a certain level. Additionally, by generalizing and determining the typical deformation parameters, the process before rock failure was divided into four stages, each with a threshold. When reaching the different thresholds, hardening and softening mechanisms influenced the loading and unloading process in different ways. Combined with fracture analysis, the influence mechanism of the stress amplitude on the deformation behavior of the sandstones entailed that with increasing stress amplitude, the stress threshold was eventually reached. Therefore, the accumulated degradation rate of the mechanical properties attributed to the softening mechanism varied, further changing the microscopic evolution characteristics of sandstone deformation. The research results provide construction guidance in geotechnical engineering.

Deformation characteristics of muddy sandstones during cyclic loading and unloading with different stress lower limits under pore pressure

Effects of Stress Lower Limit During Cyclic Loading and Unloading on Deformation Characteristics of Sandstones

Deformation Characteristics of Sandstones During Cyclic Loading and Unloading with Varying Lower Limits of Stress under Different Confining Pressures

Deformation Behavior of Sandstones During Multilevel Cyclic Loading and Unloading under Varying Lower Stress Limits: Effect of Stress Amplitude and Underlying Mechanism

EXPERIMENTAL STUDY OF EFFECTS OF CYCLIC LOADING AND UNLOADING PORE WATER PRESSURES ON DEFORMATION CHARACTERISTIC OF SANDSTONE

Experimental Research on the Deformation Characteristic of Sandstone under the Cyclic Pore Water Pressure

Effect of Unloading Rate on the Mechanical Behavior and Fracture Characteristics of Sandstones Under Complex Triaxial Stress Conditions

Experimental Analysis of the Deformation of Sandstone under Cyclic Pore Water Pressure and Wavelet Transformation

Influence of volume compression on the unloading deformation behavior of red sandstone under damage-controlled cyclic triaxial loading

Experimental Study on Strain Behavior and Permeability Evolution of Sandstone under Constant Amplitude Cyclic Loading‐unloading

Permanent Deformation Characteristics of Saturated Sand under Cyclic Loading

Study on dynamic stress-strain relationship of soft clay considering degradation of stiffness under cyclic loading

Deformation and mechanical properties of rock: effect of hydromechanical coupling under unloading conditions

Unloading mechanical properties and constitutive model of sandstone under different pore pressures and initial unloading levels

Flow Deformation and Cyclic Resistance of Saturated Loose Sand Considering Initial Static Shear Effect

Deformation characteristics and failure modes of sandstones under discontinuous multi-level cyclic loads

Study on the mechanical properties of unloading damaged sandstone under cyclic loading and unloading

Mechanical properties and energy evolution law of water bearing sandstone under cyclic loading

Experimental Analysis on the Deformation of Sandstone under Pore Pressure and Constant Time

Deformation and hysteresis behaviors of sandstone exposed to distinct sequences of variable-frequency compressive cyclic stresses

Fatigue Deformation Characteristics and Damage Model of Sandstones Subjected to Cyclic Loading: Implications for Fatigue Life Prediction