Deformation characteristics and failure modes of sandstones under discontinuous multi-level cyclic loads

Kang Peng,Jiaqi Zhou,Quanle Zou,Yongjiang Zhang,Guowen Tan
DOI: https://doi.org/10.1016/j.powtec.2020.06.076
IF: 5.64
2020-08-01
Powder Technology
Abstract:<p>Rock often suffers from discontinuous fatigue damages in geotechnical engineering, so it is of great significance to study deformation characteristics and failure modes of sandstone under discontinuous multi-level cyclic loading and unloading. By conducting continuous (only dynamic loading) and discontinuous (combined static and dynamic loading) multi-level cyclic loading and unloading tests, this study explored deformation characteristics and failure modes of sandstone. The test results demonstrated that the sandstone mainly suffered from large deformation dominated by dilation in circumferential direction when it was damaged after compression. After multi-level loading and unloading, evolution characteristics of deformation parameters showed characteristics of stepwise growth. However, the introduction of static loading changed such characteristics. In the process of combined static and dynamic loading, due to short action time, dynamic loading mainly promoted nucleation and sudden changes of cracks, while static loading affected crack development process mainly in the early compaction stage and late crack propagation and coalescence stage. Moreover, static loading showed small effects in elastic stage. In the compaction stage, the compacted micro-cracks reopened and cracks were affected by inertial damages in crack propagation stage and interconnected more thoroughly, so that the sandstone was finally more fragmented.</p>
engineering, chemical
What problem does this paper attempt to address?
The paper aims to study the deformation characteristics and failure modes of sandstone under intermittent multi-stage cyclic loading. Specifically, the authors investigate the deformation characteristics and failure modes of sandstone through continuous (only dynamic loading) and intermittent (combination of static and dynamic loading) multi-stage cyclic loading and unloading tests. The study found that sandstone damaged after compression mainly exhibits large deformation (expansion) along the circumferential direction. After multi-stage loading and unloading, the evolution characteristics of deformation parameters show a stepwise growth trend, but the introduction of static loading changes this characteristic. During the combination of static and dynamic loading, due to the short duration, dynamic loading mainly promotes crack nucleation and sudden changes, while static loading mainly affects the early compaction stage and the later crack propagation and aggregation stages in the crack development process. Additionally, in the elastic stage, the impact of static loading is minimal. In the compaction stage, compacted microcracks reopen, and during the crack propagation stage, they are affected by inertial damage, making the sandstone ultimately more fragmented. These results provide a theoretical basis for safety monitoring and disaster prevention in geological engineering.