Abstract:The purpose of this study was to explore the influence and action mechanism of the stress amplitude on the evolution of the deformation behavior of sandstones during multilevel triaxial cyclic loading and unloading (CLU) under varying lower limits of stress (VLLS). To realize this purpose, a conventional triaxial compression test under a confining pressure of 5 MPa and multilevel triaxial CLU tests under VLLS and stress amplitudes of 5, 10, and 15 MPa were independently carried out. By summarizing and analyzing the change patterns of the deformation parameters of sandstones under the different stress amplitudes, the influence law and potential action mechanism of the stress amplitude on sandstones were illustrated. The test results indicated that the increase in stress amplitude provided more opportunity for grain slippage and crack formation in sandstones, causing further softening. As a result, the ratio of the stress at the point when the bearing capacity of the tested sandstones was lost at the postpeak stage to the peak stress decreased, and the elastic modulus decreased while the Poisson's ratio increased. Based on an analysis of the evolution trend of the incremental irreversible strain, the aforementioned phenomena occurred because the change curve of the incremental irreversible strain gradually steepened with increasing stress amplitude, transitioning from a horizontal linear curve to a U-shaped curve. However, during the observed volumetric strain change, stress amplitude increase caused a reduction in cohesion in the sandstones, thus shortening the transition period from expansion to contraction. The sandstones were directly damaged without a transition period when the stress amplitude reached a certain level. Additionally, by generalizing and determining the typical deformation parameters, the process before rock failure was divided into four stages, each with a threshold. When reaching the different thresholds, hardening and softening mechanisms influenced the loading and unloading process in different ways. Combined with fracture analysis, the influence mechanism of the stress amplitude on the deformation behavior of the sandstones entailed that with increasing stress amplitude, the stress threshold was eventually reached. Therefore, the accumulated degradation rate of the mechanical properties attributed to the softening mechanism varied, further changing the microscopic evolution characteristics of sandstone deformation. The research results provide construction guidance in geotechnical engineering.

Laws of volumetric deformation and particle breaking of calcareous sand under cyclic loading

Failure Mechanisms of Sand under Asymmetrical Cyclic Loading Conditions: Experimental Observation and Constitutive Modelling

Cumulative deformations and particle breakage in calcareous sand subjected to drained high-cyclic loading: Experimental investigation

Three-dimensional Discrete Element Simulation of the Triaxial Cyclic Loading of Sandstone Based on a Nonlinear Parallel-Bonded Stress Corrosion Model

Cyclic accumulative deformation of sand and its explicit model

Permanent Deformation Characteristics of Saturated Sand under Cyclic Loading

Long-term behaviour and degradation of calcareous sand under cyclic loading

Experimental Study On Particle Breakage Of Carbonate Gravels Under Cyclic Loadings Through Large-Scale Triaxial Tests

Cyclic Deformation Behaviour of Natural K 0 -Consolidated Soft Clay under Different Stress Paths

Experimental study on the cyclic behavior of loose calcareous sand under linear stress paths

Mechanical behavior and particle breakage of calcareous sand in triaxial test

Experimental study of the mechanical behavior of calcareous sand under repeated loading-unloading

The effects of changing the deviatoric and spherical stresses during cyclic loading on the drained response of a sand

Effects of Initial Static Shear on Cyclic Resistance and Pore Pressure Generation of Saturated Sand

EXPERIMENTAL STUDY OF EFFECTS OF CYCLIC LOADING AND UNLOADING PORE WATER PRESSURES ON DEFORMATION CHARACTERISTIC OF SANDSTONE

Stress–dilatancy behavior of dense marine calcareous sand under high-cycle loading: An experimental investigation

Influence of volume compression on the unloading deformation behavior of red sandstone under damage-controlled cyclic triaxial loading

Laboratory Test on Volumetric Characteristics of Saturated Sea Sand under Cyclic Loading

Deformation Behavior of Sandstones During Multilevel Cyclic Loading and Unloading under Varying Lower Stress Limits: Effect of Stress Amplitude and Underlying Mechanism

The role of incremental stress ratio in mechanical behavior and particle breakage of calcareous sand

Experimental and Mathematical Modeling of Monotonic Behavior of Calcareous Sand