Abstract:Boiling is an efficient mode of heat transfer and has important applications that use high heat flux systems. However, a single wettable boiling surface is not appropriate for the dual requirements of low superheat for nucleation and high critical heat flux. Here, we present a hydrophilic composite and a functional hydrophilic-hydrophobic partitioned porous structure that significantly improves boiling heat transfer performance via a double-sintering process. The superheat requirement for the onset of nucleate boiling decreased from 2°C on the single hydrophilic porous structure to 1°C on the hydrophilic-hydrophobic porous structure, the critical heat flux was reduced by 3.3% in the early stages of boiling (below 250 kW/m 2 ), the heat transfer efficiency increased by 20%, and the heat transfer was comparable to that of the hydrophilic porous structure. Bubble dynamics were observed using a high-speed camera. The results demonstrate that the bubble nucleation sites mainly occur in the hydrophobic region and this is attributed to a decrease in the energy barrier for nucleation. The bubble dynamic statistics revealed that the product of the diameter of the bubble and the bubble escape frequency are similar for composite surfaces and hydrophilic porous surfaces, which is consistent with Zuber's conclusion. The synergistic effect of the hydrophilic-hydrophobic partitioned porous structure can promote nucleation in the hydrophobic region and retain capillary suction for liquid reflux in the hydrophilic region to enhance boiling heat transfer. This work enables the large-scale deployment of heat exchanger surface processing technology because of its low cost, availability, and reliability.

Negative Pressure in Water for Efficient Heat Utilization and Transfer

Hydrogels enable negative pressure in water for efficient heat utilization and transfer

Study of the Natural Circulation Flow Boiling Heat Transfer Based On Partially Superhydrophilic Surface Modification

Coupling droplets/bubbles with a liquid film for enhancing phase-change heat transfer

Non-contact optical characterization of negative pressure in hydrogel voids and microchannels

Low vaporization enthalpy hydrogels for highly efficient solar-driven interfacial evaporation

High-flux flowing interfacial water evaporation under multiple heating sources enabled by a biohybrid hydrogel

A highly efficient and sustainable heat sink via liquid film boiling in hybrid mesh with active liquid supply

Hydrogel modified evaporation interface for highly stable membrane distillation

Exploiting the potential of a novel " in-situ latent heat recovery" in hollow-fiber vacuum membrane distillation process for simultaneously improved water production and energy efficiency

Current Research Status,Difficulties and New Strategy in Utilization of Low Grade Heat

Boosting water evaporation via continuous formation of a 3D thin film through triple-level super-wicking routes

High Breakthrough Pressure in Hydrogels Enabled Ultrastable Treatment of Hypersaline Wastewaters

Synergistic Effects of Hydrophilic-Hydrophobic Porous Structures for Enhancing Nucleate Pool Boiling Heat Transfer

Porous evaporators with special wettability for low-grade heat-driven water desalination

Boosting solar-powered interfacial water evaporation by architecting 3D interconnected polymetric network in CNT cellular structure

High-Performance Janus Solar Evaporator for Water Purification with Broad Spectrum Absorption and Ultralow Heat Loss

Interfacial Radiation-Absorbing Hydrogel Film for Efficient Thermal Utilization on Solar Evaporator Surfaces

Study on Negative Pressure Multi-Stage Falling Film Evaporation in Solar Energy Seawater Desalt

High heat flux dissipation of membrane-venting heat sink with thin film boiling

Ultrathin Water Layer Conservation by "Nano-Forest" in a Three-Dimensional Interface Regulates Energy Flow to Boost Solar Evaporation.