Abstract:Dielectric barrier discharges are an emerging technology for the plasma-catalytic removal of volatile organic compounds and other gas purification challenges such as the removal of O2 traces from H2. Packed-bed reactors are mainly used for these applications, but surface dielectric barrier discharges (SDBDs) typically printed on thin dielectric plates are promising alternatives for the treatment of large volumetric flow rates due to their low flow resistance causing a low pressure drop. Especially for SDBDs the flow conditions are crucial, because the active plasma filled volume covering the mentioned plates with a typical thickness of 0.1 mm is small in comparison to the overall reactor volume with a typical distance of some tens of millimeters to the reactor wall. In this study, the flow conditions of a twin-surface dielectric barrier discharge were investigated by Schlieren imaging applied in converting O2 traces in H2 containing gas mixtures to H2O and compared to fluid dynamics simulations. Schlieren imaging was used to visualize local gradients of the refractive index inside the SDBD reaction chamber, while gas composition, dissipated power, or flow rate were varied. Without a plasma discharge, laminar flow dominates, resulting in a conversion below 10% over a Pt‐coated electrode configuration in the reaction of O2 traces with H2. With the plasma discharge, full conversion was achieved for the same reaction without catalyst, although the plasma is also confined to the surface of the electrode configuration. Schlieren structures covering the complete cross section of the reaction chamber were observed, showing that strong radial mass transport is induced by the plasma. The shape and extent of the Schlieren structures is ascribed to a superimposition of gas flow, thermal expansion from the plasma volume, thermal buoyancy as well as an electrohydrodynamic force between the electrodes and the grounded reactor walls. Fluid dynamics simulations show vortex formation above and below the electrode, created by the electrohydrodynamic force further implying extensive mass transport by the plasma, which is visualized in addition by carbonaceous deposits on the reactor lid.These findings reveal new possibilities to improve SDBD reactors for gas purification applications based on their favorable flow conditions.

Easy to assemble dielectric barrier discharge plasma ionization source based on printed circuit boards

A Novel Approach on Dielectric Barrier Discharge Using Printed Circuit Boards

Characterization of a co-planar dielectric barrier discharge design as a plasma source for trace element detection by atomic spectrometry

Characteristics of Portable Air Floating-Electrode Dielectric-Barrier-Discharge Plasmas Used for Biomedicine

Compact Plasma Ionization for Ion Mobility Spectrometry Using a 4.3 MHz Miniature Tesla Coil

Characterization of Sputter-coated Polyethylene Naphthalate-Foil as Novel Flexible Surface DBD Plasma Source

Non-thermal plasma multi-jet platform based on a flexible matrix

Ionization Wave Propagation of a Surface Dielectric Barrier Discharge with a Flexible-Structure Plasma Sheet

A dc plasma source for plasma–material interaction experiments

Demountable capillary conventional concentric nebulizer for inductively coupled plasma mass spectrometry

Development of a Dielectric Barrier Discharge Ion Source for Ambient Mass Spectrometry

A Low-Cost Demountable Direct Injection High-Efficiency Nebulizer for Inductively Coupled Plasma Mass Spectrometry

Plasma acceleration from radio-frequency discharge in dielectric capillary

Flexible plasma multi-jet source operated in radial discharge configuration

Investigation of flow characteristics in a twin-surface dielectric barrier discharge reactor by Schlieren imaging

A gapless micro-dielectric-barrier-discharge ion source for analytical applications

Diagnosis of a short-pulse dielectric barrier discharge at atmospheric pressure in helium with hydrogen-methane admixtures

One Hundred Years of Quantum Physics

A Miniaturized ECR Plasma Flood Gun for Wafer Charge Neutralization.

Plasma and Flow Simulation of the Ion Wind in a Surface Barrier Discharge Used for Gas Conversion Benchmarked by Schlieren Imaging

Coaxial tungsten hot plate-based cathode source for Cesium plasma production confined in MPD device