Abstract:We developed a low-cost, demountable direct injection high. efficiency nebulizer (DIHEN) for inductively coupled plasma mass spectrometry (ICP-MS). It consisted of an enlarged microconcentric nebulizer based body, a tapered capillary (0.25 mm i.d. and 0.37 mm o.d., 30 mu m i.d. and 40 mu m o.d. at the tip), a hollow stainless steel tubing (0.5 mm i.d. and 2.0 mm o.d.) and two adapters made from polytetrafluoroethylene (PTFE), which were assembled by epoxy resin. The tapered capillary was reproducibly fabricated according to a flame. heated two. step drawing method. After immerging into boiling water, the epoxy resin became soft and the components could be taken apart simply. Then the broken or blocked sample capillary was replaced by a new tapered capillary with the same dimensions and then they were assembled again. The optimal sensitivity was obtained when the gas flow rate was 0.27 L/min with a sample uptake rate of 50 mu L/min and a forward power of 1500 W. The sensitivities, detection limits and precisions of the homemade DIHEN under optimal operating conditions are similar, or better than those obtained with the MicroMist nebulizer, to some extent, though the polymeric ion levels of the former are higher than those of the latter. The utility of the homemade DIHEN for the analysis of small. volume samples was demonstrated by microscale flow injection analysis of Pt in serum samples. Then the homemade DIHEN was further utilized to couple microchip electrophoresis to ICP-MS for iodine speciation. The cost of the homebuilt DIHEN is about 1% price of the commercial Meinhard DIHEN, and the demountable construction permits that the blocked or broken sample capillary could be conveniently renewed with the same capillary in dimensions, obtaining low cost and easy maintenance.

Compact Plasma Ionization for Ion Mobility Spectrometry Using a 4.3 MHz Miniature Tesla Coil

Easy to assemble dielectric barrier discharge plasma ionization source based on printed circuit boards

Novel Chemical Ion Source for a High-Field Asymmetric Waveform I Mobility Spectrometer Used under Ambient Conditions

Development of an Ion Mobility Spectrometer Based on a Pulsed Photoelectric Effect Ionization Source

Plasma generation and ion beam extraction of compact microwave ion source

A Simple and Demountable Capillary Microflow Nebulizer with A Tapered Tip for Inductively Coupled Plasma Mass Spectrometry

High-Resolution Drift Tube Ion Mobility Spectrometer with Ultra-Fast Polarity Switching

A Low-Cost Demountable Direct Injection High-Efficiency Nebulizer for Inductively Coupled Plasma Mass Spectrometry

A compact ion source combining electron-impact and thermal ionization for multiple-reflection time-of-flight mass spectrometry

Electroless Ionization Mass Spectrometry Using a Compact Electrokinetic Ionization Source

Implementing of Fourier Deconvolution Multiplexing to Fast Polarity Switching Miniaturized Ion Mobility Spectrometer

Ultra-Fast Polarity Switching, Non-Radioactive Drift Tube for the Miniaturization of Drift-Time Ion Mobility Spectrometer

Towards a hand-held, fast, and sensitive gas chromatograph-ion mobility spectrometer for detecting volatile compounds

Experimental Study of a Compact Surface Flashover Ion Source

New Progress of a 2.45 GHz ECR Ion Source for Carbon Positive Ion Mass Spectrometry

Plasma Simulation and Optimization for a Miniaturized Antenna ECR Ion Source

Investigation on a compact cavity-type microwave ion source

Study of a Microwave Induced Plasma as a Universal Ion Source for Inorganic and Organic Mass Spectrometry

Unlocking the Mysteries of the Desorption-Ionization Mechanism Via Separate Thermal and Charge Strategies.

Low Temperature Plasma Diagnostics with Tunable Synchrotron Vacuum Ultraviolet Photoionization Mass Spectrometry.

Miniature Rectilinear Ion Trap Mass Spectrometry