Abstract:In equilibrium-based passive sampling applications, the accuracy of estimating freely dissolved concentration (Cfree) of hydrophobic organic compounds (HOCs) relies on the passive sampler-water partition coefficient (KPS-W) values applied. The vast majority of KPS-W are generated under standard conditions: 20 °C in deionized or freshwater. Few empirically derived values are available for non-standard conditions. In this study, polyethylene (PE)-water partitioning coefficients (KPE-W) were experimentally determined for 15 polycyclic aromatic hydrocarbons (PAHs, comprising 9 parent and 6 alkylated compounds) under three different temperature (10, 20, 30 °C) and salinity (0, 18 and 36‰) regimes, the KPE-W values were found to correlate strongly with a variety of molecular parameters (e.g., octanol-water partition coefficients (KOW), molecular weight (MW) and molecular volume (MVOL)). The effects of temperature and salinity on the magnitude of KPE-W were found to be substantial. For temperature, the values range between -0.005 and -0.023 log units per °C; these values indicate that every 10 °C rise in temperature would potentially decrease the KPE-W by a factor of between 0.4 to 1.6. For salinity, the values range from 0.0028 to 0.0057 log units per unit ‰, indicating that an 18‰ increase in salinity would likely increase the KPE-W by a factor of between 0.28 and 0.82. Moreover, temperature and salinity were shown to be independent of each other and non-interacting. Temperature effects were chemical-specific and moderately dependent on hydrophobicity (expressed as the KOW), whereas salinity effects were independent of hydrophobicity. We also assessed the combined impact of temperature and salinity, which showed increasing effects with the hydrophobicity of the PAHs studied. Based on the results, KPE-W values adjusted for site-specific temperature and salinity can be calculated. The impact of applying such site-specific values was demonstrated using a PE-based field monitoring dataset for PAHs from coastal waters of Grand Isle (LA, USA) collected during the 2010 Deepwater Horizon oil spill. When KPE-W values were adjusted to 10 °C and 30 °C, the final freely dissolved concentrations (Cfree) decreased or increased depending on the adjustment. Use of the results of this investigation allow for adjusting existing PE-based datasets to site-specific conditions resulting in more accurate Cfree values for estimating exposure and adverse ecological effects.

Equilibrium passive sampling: A novel approach to determine internal tissue concentrations of hydrophobic organic compounds in biota

Measuring Freely Dissolved DDT and Metabolites in Seawater Using Solid-Phase Microextraction with Performance Reference Compounds

Simple and Rapid Analysis of Phthalate Esters in Marine Sediment Using Ultrasound-Assisted Extraction Combined with Gas Purge Microsyringe Extraction Followed by GC-MS.

Dispersive liquid-liquid microextraction combined with gas chromatography-electron capture detection for the determination of polychlorinated biphenyls in soils.

Principles of passive sampling for ex situ measurement of hydrophobic organic compounds in sediment: Key considerations on dilution, depletion, and equilibrium

Using disposable solid-phase microextraction (SPME) to determine the freely dissolved concentration of polybrominated diphenyl ethers (PBDEs) in sediments.

Developing a consistent model for predicting equilibration in polymeric passive samplers across various HOC classes in sediment pore water

Equilibrium sampling informs tissue residue and sediment remediation for pyrethroid insecticides in mariculture: A laboratory demonstration

Application of low-density polyethylene (LDPE) passive samplers for monitoring PAHs in groundwater

Direct sample introduction GC-MS/MS for quantification of organic chemicals in mammalian tissues and blood extracted with polymers without clean-up

Solid-Phase Microextraction (spme) with Stable Isotope Calibration for Measuring Bioavailability of Hydrophobic Organic Contaminants

Passive sampling of polycyclic aromatic hydrocarbons with low-density polyethylene: Equilibration limitations in aqueous suspensions

Predicting Bioavailability of PAHs and PCBs with Porewater Concentrations Measured by Solid‐phase Microextraction Fibers

Combined temperature and salinity effects on the passive sampling of PAHs with an assessment of impacts to petroleum toxicity

High-Throughput Analysis of Selected Urinary Hydroxy Polycyclic Aromatic Hydrocarbons by an Innovative Automated Solid-Phase Microextraction

Utility of a modified o-DGT passive sampler for measurement of bisphenol analogues in freshwater and coastal waters

Combining Leaching and Passive Sampling To Measure the Mobility and Distribution between Porewater, DOC, and Colloids of Native Oxy-PAHs, N-PACs, and PAHs in Historically Contaminated Soil

Development of a novel DGT passive sampler for measuring polycyclic aromatic hydrocarbons in aquatic systems

Field and mesocosm trials on passive sampling for the study of adsorption and desorption behaviour of lipophilic toxins with a focus on OA and DTX1

Analysis of organochlorines and polycyclic aromatic hydrocarbons designed for pollutant biomonitoring in three seabird matrices

Simultaneous Focused Ultrasound Solid–Liquid Extraction and Dispersive Solid Phase Extraction Clean-Up for Gas Chromatography–Tandem Mass Spectrometry Determination of Polycyclic Aromatic Hydrocarbons in Crustacean Gammarids Meeting the Requirements of the EU Water Framework Directive