Heat Treatments for Minimization of Residual Stresses and Maximization of Tensile Strengths of Scalmalloy® Processed via Directed Energy Deposition

Rachel Boillat-Newport,Sriram Praneeth Isanaka,Jonathan Kelley,Frank Liou

DOI: https://doi.org/10.3390/ma17061333

IF: 3.4

2024-03-14

Materials

Abstract:Scalmalloy® is an Al-Mg-Sc-Zr-based alloy specifically developed for additive manufacturing (AM). This alloy is designed for use with a direct aging treatment, as recommended by the manufacturer, rather than with a multistep treatment, as often seen in conventional manufacturing. Most work with Scalmalloy® is conducted using powder bed rather than powder-fed processes. This investigation seeks to fill this knowledge gap and expand beyond single-step aging to promote an overall balanced AM-fabricated component. For this study, directed energy deposition (DED)-fabricated Scalmalloy® components were subjected to low-temperature treatments to minimize residual stresses inherent in the material due to the layer-by-layer build process. X-ray diffraction (XRD) indicated the possibility of stress minimization while reducing the detriment to mechanical strength through lower temperature treatments. Microstructural analyses consisting of energy dispersion spectroscopy (EDS) and electron backscatter diffraction (EBSD) revealed the presence of grain growth detrimentally affecting the strength and elongation made possible by very small grains inherent to AM and rapid solidification. Tensile testing determined that treatment at 175 °C for 1 h provides the best relief from the existing residual stresses; however, this is accompanied by a diminishment in the yield and tensile strength of 19 and 9.5%, respectively. It is noted that treatment at 175 °C for 2 h did not provide as great of a decrease in residual stresses, theorized to be the result of grain growth and other strengthening mechanisms further stressing the structure; however, the residual stresses are still significantly diminished compared with the as-built condition. Furthermore, a minimal reduction of the tensile strengths indicates the possibility of finding a balance between property diminishment and stress state through the work proposed here.

materials science, multidisciplinary,chemistry, physical,physics, applied, condensed matter,metallurgy & metallurgical engineering

What problem does this paper attempt to address?

This paper aims to address the issue of residual stress in Scalmalloy® alloy components during the additive manufacturing (AM) process and attempts to maintain its mechanical properties while reducing residual stress. Specifically, the study prepared Scalmalloy® components using Directed Energy Deposition (DED) technology and subjected them to low-temperature heat treatment to reduce the inherent residual stress generated by the layer-by-layer building process. The goal of the research is to find a balance that minimizes the impact on the material's tensile strength while reducing residual stress. Experimental results show that treatment at 175°C for 1 hour can maximally alleviate residual stress, but it leads to a decrease in yield strength and tensile strength by 19% and 9.5%, respectively. Additionally, the study explores the effects of heat treatment under different temperature and time conditions to find the optimal combination of heat treatment parameters.