Abstract:GeSe was theoretically predicted to have thermoelectric (TE) performance as high as SnSe. However, the relatively high TE performance was not achieved experimentally in doped GeSe samples with an original orthorhombic structure but observed in Ag(Sb,Bi)(Se,Te)2 alloyed samples that crystalize in either a rhombohedral or cubic structure. Herein, to clarify the crystal structure-dependent properties, the electrical and thermal transport properties of GeSe1–xTex (0 ≤ x ≤ 0.5), where orthorhombic, hexagonal, and rhombohedral phases are stable at room temperature for different Te content, have been studied, without any intentional manipulation on carrier concentration. It is found that the three phases show intrinsically different hole concentrations: ∼1016 cm–3 for the orthorhombic phase but as high as 1021 cm–3 for the hexagonal and rhombohedral phases. Ge-rich status in the orthorhombic phase and Ge-poor status in hexagonal and rhombohedral phases may be responsible for the huge difference in hole concentrations. The rhombohedral phase shows a much higher Seebeck coefficient than the hexagonal phase with similar hole concentration, indicating that the profile of valance band maximum for the rhombohedral structure is more favorable for high TE performance than the hexagonal phase in GeSe1–xTex. The highest zT of 0.69 has been obtained in GeSe0.55Te0.45 at 778 K, at which temperature the rhombohedral phase has already transformed to a cubic phase; however, a zT value of 1.74 at 628 K is predicted by the quality factor analysis for rhombohedral GeSe0.55Te0.45 if optimum hole concentration can be achieved.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsami.0c10850?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsami.0c10850</a>.Details for calculating transport parameters; powder XRD patterns for GeSe0.75Te0.25 with different sintering temperatures; EBSD and EDS mapping images for rhombohedral sample GeSe0.55Te0.45; and anisotropic TE properties for typical samples GeSe, Ge4Se3Te, and GeSe0.55Te0.45 (<a class="ext-link" href="/doi/suppl/10.1021/acsami.0c10850/suppl_file/am0c10850_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Dataset of the crystal structures, electrical transport properties, and first-principles electronic structures of GeTe-rich GeTe-Sb2Te3 thermoelectric materials

Crystal Symmetry Induced Structure and Bonding Manipulation Boosting Thermoelectric Performance of GeTe

Microstructures and Thermoelectric Properties of GeSbTe Based Layered Compounds

Discordant Distortion in Cubic GeMnTe2 and High Thermoelectric Properties of GeMnTe2- x%SbTe

Intrinsically Low Lattice Thermal Conductivity and Anisotropic Thermoelectric Performance in In‐doped GeSb2Te4 Single Crystals

Anisotropic Thermoelectric Properties of GeTe Single Crystal

Enhanced Thermoelectric Performance in Ge 0.955− x Sb x Te/FeGe 2 Composites Enabled by Hierarchical Defects

Electrical and Thermal Transport Properties of Ge1–xPbxCuySbyTeSe2y

Modifying Roles of CuSbSe2 in Realizing High Thermoelectric Performance of GeTe

Realizing High Thermoelectric Performance in GeTe‐Based Supersaturated Solid Solutions

Functionally Separated Electronic Band Engineering Via Multi-Element Doping Plus High-Density Defects Advances Board-Temperature-range Thermoelectric Performance in GeTe

From Stoichiometric to Off-stoichiometric GeTe: Phase Diagram Reconstruction and Thermoelectric Performance Reassessment

Structure-Dependent Thermoelectric Properties of GeSe 1– x Te x (0 ≤ x ≤ 0.5)

Enhanced near-room-temperature thermoelectric performance in GeTe

High Thermoelectric Performance of Ge–Sb–Te Nanosheets: A Density Functional Study

Enhanced thermoelectric performance in GeTe-Sb2Te3 pseudo-binary via lattice symmetry regulation and microstructure stabilization

Vacancy-Based Defect Regulation for High Thermoelectric Performance in Ge9Sb2Te12-x Compounds

High Thermoelectric Performance Achieved in Sb-Doped GeTe by Manipulating Carrier Concentration and Nanoscale Twin Grains

Rhombohedral to Cubic Conversion of GeTe via MnTe Alloying Leads to Ultralow Thermal Conductivity, Electronic Band Convergence, and High Thermoelectric Performance

Band structure and microstructure modulations enable high quality factor to elevate thermoelectric performance in Ge0.9Sb0.1Te-x%FeTe2

Off‐Centering of Ge Atoms in GeBi2Te4 and Impact on Thermoelectric Performance