Abstract:The low Seebeck coefficient and the high thermal conductivity deteriorate the thermoelectric properties of GeTe. Herein, the Seebeck coefficient is enhanced by promoting band convergency induced by the strongly correlated d, f electrons of rare earth elements. The doping of Pb and Bi causes avoided crossing and hierarchical structure, strengthening the full‐spectrum scattering of phonons and decelerating the sound velocity. As a highly promising thermoelectric material in the mid‐temperature region, pristine GeTe shows deteriorated thermoelectric properties due to the low Seebeck coefficient and the intrinsic high thermal conductivity. Herein, it is discovered that the introduction of strongly correlated d, f electrons by alloying rare‐earth atoms at Ge sites will increase the band effective mass and promote band convergency, which can largely improve the electric transport property. Moreover, the heavy atoms (Pb, Bi) doping induces optical phonon softening and the avoided crossing between acoustic and optical phonon branches, decelerating both optical and acoustic phonon velocities. The modulated composition wave from the fluctuated multi‐component distribution introduces a complicated hierarchical structure including point defects and nanoprecipitates, which provides all‐scale scattering sources for heat‐carrying phonons and results in low lattice thermal conductivity. Consequently, a high zT of 2.4 at 800 K can be obtained in the Ge0.86Pb0.09Bi0.03Ce0.005Te sample due to the combination of strong correlation for d, f electrons and the full‐spectrum scattering for phonons. This work provides an effective strategy to increase the thermoelectric performance of IV–VI compounds by combining the modulated band structure and the softening phonon dispersion.

Enhanced near-room-temperature thermoelectric performance in GeTe

Enhanced Thermoelectric Performance in GeTe by Synergy of Midgap state and Band Convergence

Enhancing thermoelectric performance in GeTe through Ge enrichment regulation and AgCuTe alloying

High Thermoelectric Performance Achieved in Sb-Doped GeTe by Manipulating Carrier Concentration and Nanoscale Twin Grains

Enhancing Near-Room-Temperature GeTe Thermoelectrics through In/Pb Co-doping

High thermoelectric performance in GeTe with compositional insensitivity

Realizing High Thermoelectric Performance in GeTe‐Based Supersaturated Solid Solutions

Medium-temperature thermoelectric GeTe: vacancy suppression and band structure engineering leading to high performance

Functionally Separated Electronic Band Engineering Via Multi-Element Doping Plus High-Density Defects Advances Board-Temperature-range Thermoelectric Performance in GeTe

Ultralow Lattice Thermal Conductivity and Superhigh Thermoelectric Figure‐of‐Merit in (Mg, Bi) Co‐Doped GeTe

Structural modulation and resonant level enable high thermoelectric performance of GeTe in the mid-to-low temperature range

Achieving Ultralow Lattice Thermal Conductivity and High Thermoelectric Performance in GeTe Alloys Via Introducing Cu2Te Nanocrystals and Resonant Level Doping.

Exceptional figure of merit achieved in boron-dispersed GeTe-based thermoelectric composites

Enhanced thermoelectric performance in GeTe-Sb2Te3 pseudo-binary via lattice symmetry regulation and microstructure stabilization

Band Modulation and Strain Fluctuation for Realizing High Average zT in GeTe

Valence Band Modification and Enhanced Phonon‐Phonon Interactions for High Thermoelectric Performance in GeTe

Achieving high thermoelectric quality factor toward high figure of merit in GeTe

Ultra-Low Thermal Conductivity and Improved Thermoelectric Performance in Tungsten-Doped GeTe

Intrinsic vacancy suppression and band convergence to enhance thermoelectric performance of (Ge, Bi, Sb)Te crystals

Simultaneous Suppression of Phonon Transport and Carrier Concentration for Efficient Rhombohedral GeTe Thermoelectric

Achieving Ultralow Lattice Thermal Conductivity and High Thermoelectric Performance in GeTe Alloys via Introducing Cu 2 Te Nanocrystals and Resonant Level Doping