Abstract:GeSe was theoretically predicted to have thermoelectric (TE) performance as high as SnSe. However, the relatively high TE performance was not achieved experimentally in doped GeSe samples with an original orthorhombic structure but observed in Ag(Sb,Bi)(Se,Te)2 alloyed samples that crystalize in either a rhombohedral or cubic structure. Herein, to clarify the crystal structure-dependent properties, the electrical and thermal transport properties of GeSe1–xTex (0 ≤ x ≤ 0.5), where orthorhombic, hexagonal, and rhombohedral phases are stable at room temperature for different Te content, have been studied, without any intentional manipulation on carrier concentration. It is found that the three phases show intrinsically different hole concentrations: ∼1016 cm–3 for the orthorhombic phase but as high as 1021 cm–3 for the hexagonal and rhombohedral phases. Ge-rich status in the orthorhombic phase and Ge-poor status in hexagonal and rhombohedral phases may be responsible for the huge difference in hole concentrations. The rhombohedral phase shows a much higher Seebeck coefficient than the hexagonal phase with similar hole concentration, indicating that the profile of valance band maximum for the rhombohedral structure is more favorable for high TE performance than the hexagonal phase in GeSe1–xTex. The highest zT of 0.69 has been obtained in GeSe0.55Te0.45 at 778 K, at which temperature the rhombohedral phase has already transformed to a cubic phase; however, a zT value of 1.74 at 628 K is predicted by the quality factor analysis for rhombohedral GeSe0.55Te0.45 if optimum hole concentration can be achieved.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsami.0c10850?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsami.0c10850</a>.Details for calculating transport parameters; powder XRD patterns for GeSe0.75Te0.25 with different sintering temperatures; EBSD and EDS mapping images for rhombohedral sample GeSe0.55Te0.45; and anisotropic TE properties for typical samples GeSe, Ge4Se3Te, and GeSe0.55Te0.45 (<a class="ext-link" href="/doi/suppl/10.1021/acsami.0c10850/suppl_file/am0c10850_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Microstructures and Thermoelectric Properties of GeSbTe Based Layered Compounds

Anionic regulation and valence band convergence boosting the thermoelectric performance of Se-alloyed GeSb 2 Te 4 single crystal

Double–layered GeTe/Sb2Te heterostructures for enhancing thermoelectric performance

Engineering the electronic band structures of novel cubic structured germanium monochalcogenides for thermoelectric applications

Mid-temperature Thermoelectric Performance of Zone-Melted Sb2(Te,Se)3 Alloys Near Phase Transition Boundary

Structural Evolution and Thermoelectric Performance in (gete)m(sb2te3)n Compounds

Intrinsically Low Lattice Thermal Conductivity and Anisotropic Thermoelectric Performance in In‐doped GeSb2Te4 Single Crystals

Two-Dimensional-Like Phonons in Three-Dimensional-Structured Rhombohedral GeSe-Based Compounds with Excellent Thermoelectric Performance

Quasi-two-dimensional GeSbTe compounds as promising thermoelectric materials with anisotropic transport properties

Modifying Roles of CuSbSe2 in Realizing High Thermoelectric Performance of GeTe

High-performance Thermoelectric Monolayer γ-GeSe and its Group-IV Monochalcogenide Isostructural Family

Enhancing the Thermoelectric Performance of GeSb4Te7 Compounds via Alloying Se

High Thermoelectric Performance Achieved in Sb-Doped GeTe by Manipulating Carrier Concentration and Nanoscale Twin Grains

High Thermoelectric Performance of New Rhombohedral Phase of GeSe Stabilized Through Alloying with AgSbSe2

Enhanced thermoelectric performance in GeTe-Sb2Te3 pseudo-binary via lattice symmetry regulation and microstructure stabilization

Thermoelectric Performance Optimization and Phase Transition of GeTe by Alloying with Orthorhombic CuSbSe 2

High Thermoelectric Performance of Ge–Sb–Te Nanosheets: A Density Functional Study

Improvement of the thermoelectric properties of GeTe- and SnTe-based semiconductors aided by the engineering based on phase diagram

Structure-Dependent Thermoelectric Properties of GeSe 1– x Te x (0 ≤ x ≤ 0.5)

Discordant Distortion in Cubic GeMnTe2 and High Thermoelectric Properties of GeMnTe2- x%SbTe

Simultaneous Suppression of Phonon Transport and Carrier Concentration for Efficient Rhombohedral GeTe Thermoelectric