Abstract:For inspection of mechanical properties and integrity of critical components such as integrated circuits or composite materials by acoustic methodology, it is imperative to evaluate their acoustic reflection coefficients, which are in close correlation with the elastic properties, thickness, density, and attenuation and interface adhesion of these layered structures. An experimental method based on angular spectrum to evaluate the acoustic coefficient as a function of the incident angle, θ, and frequency, ω, is presented with high frequency time-resolved acoustic microscopy. In order to achieve a high spatial resolution for evaluation of thin plates with thicknesses about one or two wavelengths, a point focusing transducer with a nominal center frequency of 25 MHz is adopted. By measuring the V(z, t) data in pulse mode, the reflection coefficient, R(θ, ω), can be reconstructed from its two-dimensional spectrum. It brings simplicity to experimental setup and measurement procedure since only single translation of the transducer in the vertical direction is competent for incident angle and frequency acquisition. It overcomes the disadvantages of the conventional methods requiring the spectroscopy for frequency scanning and/or ultrasonic goniometer for angular scanning. Two substrates of aluminum and Plexiglas and four stainless plates with various thicknesses of 100 μm, 150 μm, 200 μm, and 250 μm were applied. The acoustic reflection coefficients are consistent with the corresponding theoretical calculations. It opened the way of non-destructive methodology to evaluate the elastic and geometrical properties of very thin multi-layers structures simultaneously.

Road to Acquisition: Preparing a MEMS Microphone Array for Measurement of Fuselage Surface Pressure Fluctuations

Enhancing Aeroacoustic Wind Tunnel Studies through Massive Channel Upscaling with MEMS Microphones

Aeroacoustic testing on a full aircraft model at high Reynolds numbers in the European Transonic Windtunnel

A Novel Piezoresitive Microphone MEMS Sensor For Aerospace Applications

Acoustic Transmission Measurements for Extracting the Mechanical Properties of Complex 3D MEMS Transducers

Development of an innovative noise generation system for turboprop aircraft fuselage testing

Design of Acoustic Tubes Array and Application to Measuring Acoustic Loads in Supersonic Airflow

Assessment of a wind-tunnel test-bed for drone aeroacoustics in simulated flight conditions

Development of a wireless, non-intrusive, MEMS-based pressure and acoustic measurement system for large-scale operating wind turbine blades

Characterization of a Low Profile, Rapidly Deployable, MEMS Pressure Sensor Array for Aerodynamic Applications.

Flight-Testing of a MEMS Wall Shear Stress Thermal Sensor on a Microlight Aircraft

Angular Measurement of Acoustic Reflection Coefficients by the Inversion of V(z, T) Data with High Frequency Time-Resolved Acoustic Microscopy

Simultaneous Thickness, Velocity, Density, and Attenuation Measurement of a Thin Layer by Time-Resolved Acoustic Microscopy

Application investigation of microphone array measuring and testing technique in anechoic wind tunnel

Non-Contact MEMS-Sensor Array Inspection of Composites and Metallic Parts Using Lamb Waves

Acoustic testing techniques for replicating in-flight dynamic loads

Optimal Microphone Selection for Aero-engine Acoustic Measurement

MEMS directional acoustic sensor with charge amplifier based electronic readout

Miniature Ferroelectret Microphone Design and Performance Evaluation Using Laser Excitation

AeroMEMS Sensor with Integrated Pressure and Hot-Wire Sensor for High-Frequency Transition Detection

Unsteady Surface Pressure Characterization on Launch Vehicle in Liftoff Configuration