Abstract:Ultrasonic anemometers mounted on rotary-wing drones have the potential to provide a cost-efficient alternative to the classical meteorological mast-mounted counterpart for atmospheric boundary layer research. However, the propeller-induced flow may degrade the accuracy of free-stream wind velocity measurements by wind sensors mounted on drones – a fact that needs to be investigated for optimal sensor placement. Computational fluid dynamics (CFD) simulations are an alternative to experiments for studying characteristics of the propeller-induced flow but require validation. Therefore, we performed an experiment using three short-range continuous-wave Doppler lidars (light detection and ranging; DTU WindScanners) to measure the complex and turbulent three-dimensional wind field around a hovering drone at low ambient wind speeds. Good agreement is found between experimental results and those obtained using CFD simulations under similar conditions. Both methods conclude that the disturbance zone (defined as a relative deviation from the mean free-stream velocity by more than 1 %) on a horizontal plane located at 1 D (rotor diameter D of 0.71 m ) below the drone extends about 2.8 D upstream from the drone center for the horizontal wind velocity and more than 7 D for the vertical wind velocity. By comparing wind velocities along horizontal lines in the upstream direction, we find that the velocity difference between the two methods is ≤ 0.1 m s −1 (less than a 4 % difference relative to the free-stream velocity) in most cases. Both the plane and line scan results validate the reliability of the simulations. Furthermore, simulations of flow patterns in a vertical plane at the ambient speed of 1.3 m s −1 indicate that it is difficult to accurately measure the vertical wind component with less than a 1 % distortion using drone-mounted sonic anemometers.

Assessment of a wind-tunnel test-bed for drone aeroacoustics in simulated flight conditions

Experimental Study to Quantify the Rotor-to-Rotor Interaction Characteristics of a Small Unmanned-Aerial-Vehicle

A Computational Aeroacoustic Study of a Multi-Rotor Powered Urban Air Mobility Vehicle

Assessment and Mitigation of the Rotor Noise for Future Urban Air Mobility Vehicles

Development and Validation of an Aeropropulsive and Aeroacoustic Simulation Model of a Quadcopter Drone

Aeroacoustic and aerodynamic measurements at the rotor plane in the interaction of a small rotor with wings

Aeroacoustic investigation of side-by-side urban air mobility aircraft in full configuration with ground effect

Acoustic measurements of full-scale electric vertical takeoff and landing aircraft

Visual and audio perception study on drone aircraft and similar sounds in an Urban Air Mobility setting

Identification and Reduction of Interactional Noise of a Quadcopter in Hover and Forward Flight Conditions

Evaluation of different FW-H surfaces and modal decomposition techniques for the acoustic analysis of UAV propellers through detached eddy simulations

Experimental Assessment of the Flow Recirculation Effect on the Noise Measurement of a Free-Flying Multi-rotor UAS in a Closed Anechoic Chamber

On the prediction of noise generated by urban air mobility (UAM) vehicles. Part 2. Implementation of the Farassat F1A formulation into a modern surface-vorticity panel solver

Experimental Investigation of Helicopter Noise While Approaching an Elevated Helipad

An investigation into the impact of unmanned aerial vehicles on soundscape perception in urban and rural environments

Aeroacoustic testing on a full aircraft model at high Reynolds numbers in the European Transonic Windtunnel

Noise measurement of a quadrotor drone in an anechoic chamber

An Investigation of Multi-rotor Drone Noise Based on the Acoustic Hemisphere in an Actual Environment

Rotary-wing drone-induced flow – comparison of simulations with lidar measurements

An Experimental Analysis on Propeller Performance in a Climate-controlled Facility

Acoustic characterization and optimization of a subsonic closed loop wind tunnel