Mechanical and thermal conduction properties of carbon/carbon composites with different carbon matrix microstructures

Xia Liu,Hai-liang Deng,Jin-huang Zheng,Ming Sun,Hong Cui,Xiao-hu Zhang,Guang-sheng Song
DOI: https://doi.org/10.1016/s1872-5805(20)60511-x
IF: 5.7
2020-09-01
New Carbon Materials
Abstract:Four carbon/carbon composites with densities of 1.75–1.81 g/cm3were produced with matrix carbons derived from (a)coal tar pitch and furfural acetone resin by impregnation-carbonization, (b) natural gas by isothermal chemical vapor infiltration and (c) xylene by film-boiling chemical vapor infiltration. Theirmechanical properties and thermal conductivities (TC) were compared and correlated to the matrix carbon microstructures. Results showed that the strength of the composites decreased as thecarbon matrix changed from natural gas pyrocarbon (PyCN), to resin-derived carbon, to xylene PyC (PyCX), and to pitch-derived carbon. The highest flexural and interlaminar shear strengths of 208.7 and 26.4MPa, respectively, were obtained for the PyCN matrix. The large amount of fiber pull-out and step-like matrix fracture contributed to a high toughness of composites with PyCN and PyCX matrices. Relatively low strength and toughness were obtained for the pitch-derived carbon. The change of TC with the matrix type was consistent with the graphitization degree and apparent crystallite height. The highest in-plane and out-of-plane TC reached 148.2 and 75.4 W/(m·K), respectively, for the PyCX matrix, which was due to its carbon layers having the highest preferred orientation. The chaotic structure and large number of defects of the resin-derived carbon produced a relatively low TC. PyCN was the most suitable matrix for composites with excellent mechanical properties. PyCXshould be used to improve the TC and toughness of the low-cost composites.
materials science, multidisciplinary
What problem does this paper attempt to address?
The text contains two case summaries, each describing different issues encountered during percutaneous coronary intervention (PCI). ### First Case Summary - **Issue**: This case discusses the problem of stent edge dissection due to vessel tortuosity. The patient suddenly experienced chest pain, nausea, and ST-segment elevation on the electrocardiogram within 30 minutes after undergoing PCI. Emergency coronary angiography revealed complete occlusion at the proximal stent site of the right coronary artery (RCA). - **Solution**: By performing a repeat PCI, using a cutting balloon to establish a re-entry point, and implanting two everolimus-eluting stents (Xience Alpine), blood flow was restored, and the patient's symptoms were alleviated. ### Second Case Summary - **Issue**: This case explores a method for managing a complex calcified lesion. The patient is an 83-year-old male with multiple cardiovascular risk factors, including diabetes, hypertension, and hyperlipidemia. He presented with exertional chest tightness three years ago, and coronary angiography showed triple vessel disease. Drug-eluting stents (DES) were implanted in the left anterior descending artery (LAD) and the right coronary artery (RCA), but the left circumflex artery (LCX) was highly calcified and extensively diseased, so medical therapy was chosen. - **Solution**: Eight months later, the patient was re-admitted for exertional angina. Although specific treatment methods were not detailed, the case highlights the challenges in managing complex calcified lesions. Overall, these two summaries focus on two different complications encountered during PCI and their management strategies. The first case emphasizes stent edge dissection, while the second case discusses the handling of complex calcified lesions.