Abstract:The paper reports the main features of electrochemical deposition of nickel-iron alloy from electrolyte based on the eutectic mixture of choline chloride and ethylene glycol, which is a typical representative of a new type of ionic liquids, deep eutectic solvents (DES). It is found that the iron content in the deposited alloy increases with both increasing the applied cathode current density and increasing the concentration of iron ions in the electrolyte and the introduction of water additives. Thus, variation in the current density and the concentration of water additive in electrolytes based on DES is the factor of influence on the kinetics of partial electrode reactions, and hence on the composition and properties of the coating. It is shown that it is possible to deposit uniform coatings with iron content up to 10–13% from the investigated electrolyte containing water additive (up to 10 wt.%) at the deposition current density not exceeding 1–1.2 A/dm2. The current efficiency of the alloy deposition is close to the theoretical value (97–99%), i.e. the electrodeposition is practically not complicated by electrochemical processes involving components of a deep eutectic solvent. The surface of pure nickel deposited from an electrolyte based on DES without additional water is quite uniform with a small number of defects, pitting and small pores, while coatings deposited from the electrolyte containing water additives are characterized by granular surface morphology with many asymmetric spheroidal crystallites. The electrodeposition of a nickel-iron alloy yields the surface built of irregular spheroids that overlap and form a scaly-like type of surface morphology. Nickel-iron electrolytic coatings containing up to ~7% Fe, formed from the ethaline-based electrolyte, are nanocrystalline solutions of iron in nickel with a face-centered cubic nickel lattice and an average nanocrystallite size of about 6–15 nm. Nickel-iron alloy coatings electrochemically deposited under the conditions established in this work may be considered as promising electrode materials for the creation of new cheap and highly efficient electrocatalysts for water electrolysis in hydrogen energy.

Electrodeposition of Ni from Choline Chloride/Ethylene Glycol Deep Eutectic Solvent and Pure Ethylene Glycol

Nickel electrodeposition from deep eutectic solvents containing copper ions at a high temperature

Study on electrodeposition behaviour and corrosion resistance of nickel-copper alloy in ChCl-EG deep eutectic solvents

Initial stages of electrocrystallization of nickel, iron and nickel-iron alloy on a glassy carbon electrode in an electrolyte based on a eutectic mixture of choline chloride and ethylene glycol

Electrodeposition of Ni–Sn alloy from ethylene glycol electrolyte. Part 2. Reactions in the bulk electrolyte

Electrodeposition of Ni–Mo alloy coatings from choline chloride and propylene glycol deep eutectic solvent plating bath

Electrodeposition of Ni–Co alloys from a deep eutectic solvent

Influence of Electrodeposition Conditions on the Microstructure and Corrosion Resistance of Zn–Ni Alloy Coatings from a Deep Eutectic Solvent

Effect of Additive Methyl Nicotinate on Electrochemical Behavior of Nickel–Copper Alloy Electrodeposition in ChCl-EG Deep Eutectic Solvents

ELECTRODEPOSITION OF NANOCRYSTALLINE NICKEL-IRON ALLOY FROM AN ELECTROLYTE BASED ON A NEW TYPE OF IONIC LIQUIDS – DEEP EUTECTIC SOLVENT

Microstructure, nanoindentation, and electrochemical properties of the nanocrystalline nickel film electrodeposited from choline chloride–ethylene glycol

Electrochemical Behaviour of Nickel(II)-Rhenium(VII) And Electrodeposition Of Nickel-Rhenium Alloy From Choline Chloride - Urea Deep Eutectic Solvent

Electrochemical study of Ni deposition on carbon microfiber

Effect of EDTA and NH 4 Cl additives on electrodeposition of Zn–Ni films from choline chloride-based ionic liquid

The role of electrolyte ratio in electrodeposition of nanoscale Fe Cr alloy from choline chloride-ethylene glycol ionic liquid: A suitable layer for corrosion resistance

Electrodeposition of zinc-nickel alloys from ethylene glycol-based electrolytes in presence of additives for corrosion protection

The use of ionic liquids based on choline chloride for metal deposition: A green alternative?

Electrodeposition of copper on glassy carbon and palladium from choline chloride - ethylene glycol deep eutectic solvent

Nickel electrowinning using a Pt catalysed hydrogen-diffusion anode. Part I: Effect of chloride and sulfate ions and a magnetic field

Electrodeposition of Nanocrystalline Chromium Coatings from 1-Butyl-3-methylimidazolium-hydrogen Sulfate Ionic Liquid

Electroplating Behavior of Zn-Ni Alloys in an Alkaline Electrolyte