Abstract:In a solid oxide fuel cell power system, large planar cells are common central parts for electric generation. In practice, the operating conditions of a planar cell may have significant impact on the electrical efficiency and the lifespan of the cell, thus the operating and maintenance cost of the power system. Given varying electric load, the power system would dynamically adjust the operating conditions of each cell or cell module, so that the energy and heat balance in the system is maintained, the fuel consumption is minimized and the cells are protected from reactant starvation, local overheating etc. To realize this functionality, we seek a fundamental understanding of the quantitative connections among fuel cell properties, operating conditions and optimal electrical efficiency. We established a quasi-2D model for quick evaluation of fuel and oxidant concentration and current density along the flow direction. For fuel cells with very low charge transfer impedance i.e. 0.02 Ω*cm^2 operating with low fuel flow rates, the fuel concentration at the exit may reach an equilibrium where the local Nernstian potential across the cell equals the cell voltage. In such cases, the fuel utilization remains almost constant regardless of varying fuel flow rate, given a certain cell voltage. For fuel cells with local charge transfer impedance of 0.5 Ω*cm^2 operating with high fuel flow rates, such phenomenon was not observed because the fuel concentration at the exit depends strongly on the fuel flow rate. Given the fuel molar fraction at the fuel inlet, the electrical efficiency of a fuel cell has its maximum at certain cell voltage, which depends strongly on the charge transfer impedance of the fuel cell. At constant fuel flow rates, the optimal cell voltage increases with lowering charge transfer impedance. The optimal electrical efficiency appears lower with higher inlet fuel molar fraction. Given fixed and uniform fuel cell temperature, the air flow rate has little impact on the electrical efficiency for air-fuel stoichiometric ratios above 1.3. Besides the above findings, further studies are necessary on the effects of temperature distribution as well as porous electrode diffusion resistance. Figure 1

Performance and thermal optimization of different length-width ratio for air-cooled open-cathode fuel cell

Numerical Simulation and Optimization of Operating and Structural Parameters for Solid Oxide Fuel Cell

Numerical Modeling and Current Collection Designs for Flat-Chip Solid Oxide Fuel Cell

Novel optimal structure design and testing of air-cooled open-cathode proton exchange membrane fuel cell

Performance improvement and numerical study on cathode channel for air-cooled open-cathode proton exchange membrane fuel cells

Performance and design optimization of different numbers and bolt torque for air-cooled open-cathode proton exchange membrane fuel cells

Experimental Investigation on the Anode Flow Field Design for an Air-Cooled Open-Cathode Proton Exchange Membrane Fuel Cell

Testing Study of Different Flow Direction and Structure for Air-Cooled Proton Exchange Membrane Fuel Cell

The Performance Improvement of Membrane and Electrode Assembly in Open-Cathode Proton Exchange Membrane Fuel Cell

Experimental study on the thermal management of an open-cathode air-cooled proton exchange membrane fuel cell stack with ultra-thin metal bipolar plates

Air and H2 feed systems optimization for open-cathode proton exchange membrane fuel cells

Temperature Optimization and Control of Optimal Performance for a 300W Open Cathode Proton Exchange Membrane Fuel Cell

Anode-Oxidizing Critical Operating Conditions of Large Planar Solid Oxide Fuel Cell

Structural design and optimization for a 20-cell solid oxide fuel cell stack based on flow uniformity and pressure drop

Analyzing Key Factors Influencing Water Transport in Open Air-Cooled PEM Fuel Cells

Variational-principle-optimized porosity distribution in gas diffusion layer of high-temperature PEM fuel cells

Evaluation of performance and mass transfer characteristics by applying oblique fin flow field to air-cooled PEMFCs under different ambient conditions

Study of the Influences of Fuel Utilization on Efficiency and Anode Safety at Different Fuel Flow Rates for Industrial-Size Solid Oxide Fuel Cell

Optimal Interval of Air Stoichiometry under Different Operating Parameters and Electrical Load Conditions of Proton Exchange Membrane Fuel Cell

Improved flow field design for air-cooled proton exchange membrane fuel cells

Effect of cathode channel structure on the performance of open-cathode proton exchange membrane fuel cell in dry environments