Laser directed energy deposition remanufacturing of LPBF-processed TA15 parts: Hybrid process interface induced microstructure inheritance and mechanical performance

Xinyu Shi,Dongdong Gu,Guangjing Huang,Yanze Li

DOI: https://doi.org/10.1016/j.jmrt.2024.10.018

IF: 6.267

2024-10-10

Journal of Materials Research and Technology

Abstract:The laser additive hybrid manufacturing technology, which combines the precision of Laser Powder Bed Fusion (LPBF) and the flexibility of Laser Directed Energy Deposition (LDED), provides an effective solution for efficient forming and remanufacturing of large, complex components. The bonding zone (BZ) between LPBF and LDED forming regions is crucial for the final component performance. This study utilized LDED to remanufacture annealed LPBF substrates and investigated the microstructure and mechanical properties of TA15 alloy remanufactured parts. Results shows that a gradient microstructure forms at the bonding zone (BZ), where the bottom region exhibits a mixed structure including transitional β phase (β t ), lamellar α and secondary α phase (α s ). The top region shows a "ghost structure" of fine needle-like α phases. The mechanical property matched the microstructure well, as the hardness in the upper BZ reaches up to 463 MPa, whereas the LFZ exhibits the lowest hardness at 401 MPa. As the angle between the LDED region edge and tensile direction increases, the tensile strength first increases and then stabilizes, while elongation increases initially and then decreases. At a tilt angle of 60°, the strength peaks at 1098 MPa; at a 30° angle, the elongation reaches a maximum of 10.336%. All samples fracture at the LPBF zone, indicating that the formation of fine lamellar α phases in the BZ contributes to its higher strength compared to LPBF substrate and LDED deposition zones.

materials science, multidisciplinary,metallurgy & metallurgical engineering