Abstract:<p>A circumferential crack in the fusion line is a major threat to the structural integrity of the pipeline girth weld because it may possibly lead to fracture failure when subjected to large plastic deformations. For the newly constructed X80 pipeline with an outside diameter (OD) of 1422 mm in China, the complicated configuration of welded joints and the outer diameter are outside the range of the general fracture assessment standards, such as BS 7910. Furthermore, during the pipe manufacture process, pipeline designers merely specify the minimum yield strength limit according to the pipe steel grade. This results in a wide variation range in the choice of yield strength values of the base metal. This also leads to a serious problem in the fracture assessment of pipe girth weld because the weld strength is commonly considered to be either evenly matched or overmatched. The foregoing factors make it difficult to perform an accurate fracture assessment using conventional standards. This study therefore aims to investigate the fracture behavior of 1422-mm OD pipelines with a double-V groove weld and circumferential crack in the fusion line. The specific effect of material mismatch and the realistic operational parameters that influence the fracture capacity of the pipe are examined via a series of numerical investigations. First, a rigorous three-dimensional finite element model to simulate the pipe girth weld is established by utilizing the ABAQUS finite element code package. The weld, which has a canoe-shaped surface crack in the fusion line between the heat-affected zone and root welding metal, is subjected to biaxial loading conditions. The keyhole method is adopted to simulate the crack front as well as the crack tip to eliminate the stress singularity effect during deformation. A refined mesh strategy is introduced to ensure the accurate simulation of the stress and strain fields in the vicinity of the crack tip. Based on the numerical model, the J-integral fracture parameter, which is clearly defined based on a strict mechanical theory, is chosen to characterize the effect of strength matching ratio, internal pressure, and yield to tensile strength ratio on the crack driving force. A new strain-based J-integral prediction formula is proposed based on numerical results.</p>

Failure analysis of fillet weld crack in linepipe

Cause Analyses of the Weld Seam Cracks of a Prehydrogenating Reactor

Failure Analysis of Girth Weld Cracking in Gas Transmission Pipelines Subjected to Ground Subsidence and Traffic Loads

Failure analysis of L415/316L composite pipe welded joint

Failure Causes Analysis of Circumferential Cracking on Gathering Pipeline in M Oil and Gas Field

Fracture response of 1422-mm diameter pipe with double-V groove weld joints and circumferential crack in fusion line

Failure Analysis of Cracked P110 Repaired Tubing Used for Gas Transmission

The Effect of Pipeline Root Weld Microstructure on Crack Growth Behaviour

Welding residual stress analysis of the X80 pipeline: simulation and validation

Root cause analysis of cracking in buried X80 natural gas pipelines

Fracture behavior analysis of X80 pipelines welded joints with unequal wall thickness

Cause Analysis of Leakage Failure of Seamless Steel Pipe during Pipeline Pressure Test

Fracture analysis of X80 welded joints with variable wall thickness and misalignment

Full-scale experimental investigation of the fracture behaviours of welding joints of APL X80 wide plate based on DIC technology

Analysis and Repair of Cracks in Welding Tee of Main Steam Pipelines in Thermal Power Units

Fracture Response of X80 Pipe Girth Welds under Combined Internal Pressure and Bending Moment

Failure analysis of 2205 duplex stainless steel connecting pipe for composite plate pressure vessel in a high pressure gas field

Effects of in-service strain on girth weld failure of an X80 pipeline

Cracking Analysis on X80 Steel Oil Pipe during JCOE Forming

Analysis on Cracking of a Pipeline Steel Pipe during Hydraulic Burst Test

Failure Analysis of Leakage Occurred in Tee in Steam Pipeline Connected to Heating Furnace