Abstract:The direct synthesis of light olefins from syngas via Fischer-Tropsch synthesis reaction is a promising technology for direct synthesis of olefins from syngas. The key is to improve the selectivity of light olefins through the regulation of product distribution. In this work, the hydrophobic Fe@Si catalyst was prepared by room temperature solid state methodStober-silylation method, and then the catalyst was combined with SAPO-34 molecular sieves with different contents to prepare Fe@Si/S-34 composite catalysts. The effects of SAPO-34 molecular sieve content on the physicochemical properties of the catalysts were investigated by X-ray diffraction, scanning electron microscopy, N-2 adsorption-desorption, NH3 temperature programmed desorption and water contact angle measurement. The results showed that the content of SAPO-34 molecular sieve has significant influence on the surface area, pore volume, acidity and hydrophobicity of the catalysts. With the increase of SAPO-34 molecular sieve content, the specific surface area and total pore volume of the catalyst increased, the weak acid and medium-strong acid sites increased, and the hydrophobicity weakened. The catalytic performance evaluation results showed that the Fe@Si/S-34 composite catalyst decomposed C5+ hydrocarbons into light hydrocarbons, significantly reduced the selectivity of C5+ products and increased the selectivity of C2 similar to C4 hydrocarbons. Appropriate SAPO-34 molecular sieve could significantly improve the selectivity of C2 similar to C-4 olefins. When the mass ratio of Fe@Si catalyst to SAPO-34 is 2, the C-2 similar to C-4 olefin selectivity of Fe@Si/S-34 catalyst is the highest, the conversion of CO is 80.0%, the selectivity of CO2 in the product is 8.9%, and the selectivity of C-2 similar to C-4 olefins is 31.1%. In this study, the hydrophobicity of Fe@Si catalyst and the cracking activity of SAPO-34 molecular sieve for C5+ hydrocarbon were coupled together to inhibit the water-gas shift (WGS) reaction, reduce the CO2 selectivity and obtain higher C-2 similar to C-4 olefin selectivity, which provided a new strategy for the development of catalysts for Fischer-Tropsch synthesis to olefins.

Development of Fe-based catalysts for CO 2 hydrogenation to higher hydrocarbons for operating in slurry reactor

Preparation of Fe@Si/S-34 Catalysts and Its Catalytic Performance for Syngas to Olefins

Slurry-phase CO2 Hydrogenation to Hydrocarbons over a Precipitated Fe-Cu-Al/K Catalyst: Investigation of Reaction Conditions

Liquid-phase preparation of CuO/ZrO2 catalyst used in slurry reactors and its catalytic activity for CO hydrogenation

Reactive ball-milling synthesis of Co-Fe bimetallic catalyst for efficient hydrogenation of carbon dioxide to value-added hydrocarbons

Promotion effect of Fe–Cu catalyst for the hydrogenation of CO2 and application to slurry reactor

Developing Multifunctional Fe-Based Catalysts for the Direct Hydrogenation of CO2 in Power Plant Flue Gas to Light Olefins

Fe‐Based Catalysts for the Direct Photohydrogenation of CO 2 to Value‐Added Hydrocarbons

Heterogeneous Catalytic Systems for Carbon Dioxide Hydrogenation to Value-Added Chemicals

CO2 Hydrogenation to Hydrocarbons over Fe‐Based Catalysts: Status and Recent Developments

Residue Upgrading in Slurry Phase over Ultra-fine NiMo/gamma-Al2O3 Catalyst

Synthesis of Liquid Hydrocarbon via Direct Hydrogenation of CO2 over FeCu-Based Bifunctional Catalyst Derived from Layered Double Hydroxides

Isolated dual-active Fe-Co sites efficiently promote CO 2 hydrogenation upgrading

Selectivity control between reverse water-gas shift and fischer-tropsch synthesis in carbon-supported iron-based catalysts for CO 2 hydrogenation

CO 2 Hydrogenation to Methanol in a Slurry Reactor: Catalytic Performance of CuO-Enhanced In 2 O 3 /ZrO 2

Mechanistic Insight into Hydrocarbon Synthesis via CO2 Hydrogenation on χ-Fe5C2 Catalysts

Facet-Controlled Cu-doped and K-promoted Fe2O3 nanosheets for efficient CO2 hydrogenation to liquid hydrocarbons

Enhancing the synergism of Fe3O4 and Fe5C2 to improve the process of CO2 hydrogenation to olefines

A versatile hybrid catalyst platform of Na/ZnFe2O4 and zeolite for selective hydrocarbon production from CO2 hydrogenation

Plasma‐driven CO2 hydrogenation to CH3OH over Fe2O3/γ‐Al2O3 catalyst

Direct hydrogenation of CO 2 to liquid hydrocarbons over K/Fe-C catalysts: Effect of porous carbon matrix and K modification