Abstract:Hybrid joints combining pre-tensioned bolts and adhesive bonding have been shown to have the potential to increase joint loading capacity for steel structures. In this paper, experimental and numerical research on hybrid joints has been reviewed with a focus on load transfer mechanisms. However, there is still no clear consensus on whether hybrid joints are an extension of a pre-tensioned bolted connection with an increased friction coefficient or adhesively bonded ones. This is due to the complexity of hybrid joints, which require knowledge from two different fields of engineering and can result in incomplete characterisation of adhesives and documentation of manufacturing and testing large-scale samples. The first part of the review paper discusses the experimental evidence gathered on small-scale samples (Napkin and off-axis tests), although not strictly resulting from observations directly made on hybrid joints. The authors that studied the σ - τ –interaction on both tensile and compressive normal stresses provided evidence of a clear distinction to be made between tensile and compressive normal stresses. For tensile normal stresses, there is a clear lower limit below which no shear strength exists, while compressive stresses significantly increase shear strength. However, there is no clear consensus regarding the exact nature of the interaction between compressive normal stresses and shear strength. Some authors assume a linear relationship involving some cohesive strength, while others identified bi-linear or more complex relationships. Adhesives do not exhibit any noteworthy differences in the friction coefficient, and differences related to the failure mode were identified: cohesive failure is likely driven by the intrinsic strength of the adhesive, while adhesive failure can be modelled as a classic friction problem. Relating the aforesaid to the adhesive, or specific properties thereof, proved difficult, as most of the studies do not provide sufficient information. Additional complexity arises if tests are carried out on galvanised or coated surfaces, in which case the performance of the adhesive may be subordinated to that of the specific steel surface. Overall, the review paper provides valuable insights into the load transfer mechanisms of hybrid joints, but further research is necessary to fully understand their behaviour and to optimise their design for use in steel structures.

Influence of the joining technique on the structural behaviour of hybrid timber-steel cross-sections

Bending Behavior of Hybrid Timber–Steel Beams

Experimental and numerical analysis of tensile properties in steel-timber bonded-screwed hybrid single-lap joints with different drilling directions

Experimental and Numerical Investigations on the Hybrid Dowel and Bonding Steel Plate Joints for Timber Structures

Strengthening Single-Bolt Timber Joints with Externally Bonded CFRP Composites

Experimental Analysis of Bonding in Steel Glued into Pine Timber

Longitudinal Shear in Timber–Concrete Composites with Flexible Adhesive Connections—Experimental and Numerical Investigations

Hybrid joints consisting of pre-tensioned bolts and a bonded connection—A comprehensive review part I: Local approach

A review of factors influencing the durability of structural bonded timber joints

Proposing new adhesive-free timber edge connections for cross-laminated timber panels: A step toward sustainable construction

Experimental testing of post-tensioned steel-timber hybrid frames equipped with energy-dissipating braces

Shear performance of a novel non-metallic cross-laminated timber wall-to-wall connection using double-dovetail mortise-tenon joint

Dynamic Characteristics of Adhesive Bonded High Strength Steel Joints

Stiffness of steel‐to‐timber connection under cyclic loading

Numerical modelling of the structural response of a novel hybrid densified wood filled-aluminium tube dowel for structural timber connections

Mechanical properties of timber-concrete connections with steel tube connectors

In-plane testing and hysteretic modeling of steel-spline cross-laminated timber diaphragm connection with self-tapping screws

Experimental investigation on novel shear connections for demountable steel-timber composite (STC) beams and flooring systems

Influence of test methodology on the characterization of the parallel-to-grain timber embedment strength and foundation modulus of dowels

Glulam beams adhesively bonded by birch plywood plates in moment-resisting beam-to-beam connections

Failure mechanisms in pre-tensioned bonded hybrid joints