Abstract:Results are presented for modelling of the evaporation and magnetron sputter deposition of Zn(x)O(y) onto an O-terminated ZnO (0001¯) wurtzite surface. Growth was simulated through a combination of molecular dynamics (MD) and an on-the-fly kinetic Monte Carlo (otf-KMC) method, which finds diffusion pathways and barriers without prior knowledge of transitions. We examine the effects of varying experimental parameters, such as substrate bias, distribution of the deposition species and annealing temperature. It was found when comparing evaporation and sputtering growth that the latter process results in a denser and more crystalline structure, due to the higher deposition energy of the arriving species. The evaporation growth also exhibits more stacking faults than the sputtered growth. Post-annealing at 770 K did not allow complete recrystallization, resulting in films which still had stacking faults where monolayers formed in the zinc blende phase, whereas annealing at 920 K enabled the complete recrystallization of some films to the wurtzite structure. At the latter temperature atoms could also sometimes be locked in the zinc blende phase after annealing. When full recrystallization did not take place, both wurtzite and zinc blende phases were seen in the same layer, resulting in a phase boundary. Investigation of the various distributions of deposition species showed that, during evaporation, the best quality film resulted from a stoichiometric distribution where only ZnO clusters were deposited. During sputtering, however, the best quality film resulted from a slightly O rich distribution. Two stoichiometric distributions, one involving mainly ZnO clusters and the other involving mainly single species, showed that the distribution of deposition species makes a huge impact on the grown film. The deposition of predominantly single species causes many more O atoms at the surface to be sputtered or reflected, resulting in an O deficiency of up to 18% in the deposited film and therefore resulting in more stacking faults and phase boundaries. The methods used allow analysis of key mechanisms that occur during the growth process and give hints as to the optimum conditions under which complete crystalline layers can form.

Influence of Substrate Polarity on Thermal Stability, Grain Growth and Atomic Interface Structure of Au Thin Films on ZnO Surfaces

Substrate Polarity and Surface Pretreatment Temperature Dependence of ZnO Homoepitaxy

Influence Of Substrate Temperature On The Structure And Electric Properties Of Zno Films

Low-Temperature Epitaxy Of Zno Films On Si(001) And Silica By Reactive E-Beam Evaporation

Modelling the growth of ZnO thin films by PVD methods and the effects of post-annealing

Influence of Post-Annealing Treatment on the Structure Properties of ZnO Films

Growth, structure, and stability of Au on ordered ZrO2(111) thin films

Structural and Optical Properties of Highly (110)-Oriented Non-Polar ZnO Evaporated Films on Si Substrates

Study on ZnO/α-Al2O3 Interface Structure by X-ray Grazing Incident Diffraction

Microstructure and Polarity of Epitaxial ZnO Films Grown on LSAT(111) Substrate Studied by Transmission Electron Microscopy

Thermal annealing effect on optical properties of electrodeposited ZnO thin films

Influence of Postdeposition Annealing on the Properties of ZnO Films Prepared by RF Magnetron Sputtering

The Effect of Annealing Temperature on the Properties of ZnO Films with Preferential Nonpolar Plane Orientation by SSCVD

Influence of film thickness and annealing temperature on the structural and optical properties of ZnO thin films on Si (100) substrates grown by atomic layer deposition

Interfacial and Microstructural Changes of the Al2O3/ZnO Multilayer Films Induced by In-Situ Growth and Post-Annealing Temperatures

Effect of High Temperature Thermal Treatment of (100) Γ-Lialo2 Substrate on Epitaxial Growth of ZnO Films by Plasma-Assisted Molecular Beam Epitaxy

Surface Morphologies of Homoepitaxial Zno on Zn- and O-Polar Substrates by Plasma Assisted Molecular Beam Epitaxy

Controlled Growth Of Zn-Polar Zno Films On Al-Terminated Alpha-Al2o3(0001) Surface By Using Wurtzite Mgo Buffer

Growth of ZnO thin films on LSAT(111) substrates by plasma-assisted radio-frequency molecular beam epitaxy

Ab Initio Thermodynamic Study on Two-Dimensional Atomic Nucleation on ZnO Polar Surfaces

Influence of Postdeposition Annealing on Crystallinity of Zinc Oxide Films