Abstract:Selective catalytic reduction (SCR) is a crucial technique for mitigating nitrogen oxides emission of internal combustion engines. Compared with vanadium-based catalysts, copper-based molecular sieve catalysts exhibit superior low-temperature catalytic performance and anti-aging properties. The catalytic characteristics of Cu-SSZ-13 catalyst in both fresh and aged states are investigated through experimental and numerical simulations. The catalytic performance of Cu-SSZ-13 catalyst with 200 g/L coating is investigated under wide inlet temperatures (180 °C–450 °C) and ANR (ammonia to nitrogen ratio) (1–1.4) conditions via an engine emission test device. Further, the apparatus is adopted to evaluate performance at various aging temperatures (600 °C, 700 °C, and 800 °C). The aging factor is introduced based on experimental results to establish and correct the kinetic model for SCR aging state. The results illuminate that the increase of ANR fails to compensate for decline of catalytic efficiency under low-temperature conditions (150 °C).The generated quantity of isocyanate acid through the side reaction of urea hydrolysis increases proportionally with ANR. And it increased supply only resulted in a marginal 1 %–3 % improvement of catalytic efficiency. As SV decreases from 60,000 h −1 to 35,000 h −1 , the catalyst efficiency increases from 22 % to 45 %, resulting in an elevation of reactant concentration and its gradient on the catalyst surface. This leads to accelerated reaction rates and enhanced diffusion effects. The catalytic efficiency can be significantly enhanced at low temperatures when NO 2 fraction in NOx falls within the range of 10 %–25 %. The sensitivity of SCR reactions to aging varies at low temperatures (<250 °C) due to the distinct reaction sites on catalyst for different types of SCR reactions. The NO 2 SCR reactions exhibit minimal susceptibility, while the rapid SCR reactions are significantly impeded. Moreover, it has been observed that the catalyst microstructure was completely deteriorated under hydrothermal aging test at 900 °C operating condition. In general, the low-temperature catalytic performance of Cu-SSZ-13 catalyst can be further optimized by pretreating inlet gas components and optimizing the catalyst structure.

Deactivation of Cu-SAPO-34 by urea-related deposits at low temperatures and the regeneration

Urea-related Reactions and Their Active Sites over Cu-SAPO-34: Formation of NH3 and Conversion of HNCO

Effect of urea thermal decomposition on diesel NOx-SCR aftertreatment systems

Investigation on the urea deposit formation and thermal decomposition characteristics in the SCR aftertreatment system of a diesel engine

Deactivation and Regeneration for the SO2-Poisoning of a Cu-SSZ-13 Catalyst in the NH3-SCR Reaction

Critical Roles of Cu(OH)2 in Low-Temperature Moisture-Induced Degradation of Cu-SAPO-34 SCR Catalyst: Correlating Reversible and Irreversible Deactivation

In situ regeneration of sulfated Cu/SAPO-34 catalyst for the selective catalytic reduction of NOx with NH3

Impact of Diesel Emission Fluid Soaking on the Performance of Cu-zeolite Catalysts for Diesel NH3-SCR Systems

Experimental and numerical study of Cu-SSZ-13 SCR system for NOx reduction and hydrothermal aging under diesel exhaust conditions

Catalytic deactivation mechanism research over Cu/SAPO-34 catalysts for NH3-SCR (I): The impact of 950 °c hydrothermal aging time

Nature Identification of Cu Active Sites in Sulfur-Fouled Cu/SAPO-34 Regeneration

The Effect of Sulfate Species on the Activity of NH3-SCR over Cu/SAPO-34

The influence of sodium on the catalytic properties, low-temperature hydrothermal stability, and sulfur resistance of Cu-SAPO-34 for NOx reduction by NH3-SCR

Laser Raman Spectroscopic Investigation on the Conversion of Molten Urea into NH3 for the Selective Catalytic Reduction of NOx in Oxygen-Rich Exhaust Gases

Experimental Study on Urea Deposits of Urea-SCR System for Heavy Duty Diesel Engines

Numerical Investigation on the Urea Deposit Formation Process in a Selective Catalytic Reduction System of a Diesel Engine Based on a Fluid–Solid Coupling Method

Effects of regeneration conditions on sulfated CuSSZ-13 catalyst for NH 3 -SCR

Review on Selective Catalytic Reduction Technology of Diesel Engines

Experimental Study on the Effects of the Exhaust Atmosphere on SO<sub>2</sub> Poisoning over the Cu-SSZ-13 SCR Catalyst

Effects of Catalyst Physicochemical Properties on the Catalytic Activity of Cu Zeolite Selective Catalytic Reduction at Different Inlet Gas Conditions

Characterization of Commercial Cu-SSZ-13 and Cu-SAPO-34 Catalysts with Hydrothermal Treatment for NH3-SCR of NOx in Diesel Exhaust