Abstract:Calcium aluminate phases have a particular effect on the early heat release during setting initiation and have a substantial influence on the further workability of ordinary Portland cement. The nature of the calcium aluminate hydration products and its kinetics strongly depends on sulfate content and humidity. The effect of mineralisers on melt formation and viscosity is well described for calcium silicate systems, but information is still lacking for calcium aluminates. Therefore, the synergistic effect on the crystal structure and hydration mechanism of the tricalcium aluminate phase of the addition of mineralizers, i.e. Li 2 O, CuO, SO 3 to the raw meal is here investigated. Co-doped calcium aluminate structures were formed during high-temperature treatment. Thermal analysis (TG–DTA and heating microscopy) was used to describe the ongoing high-temperature reaction. Resulting phase composition was dependent on the concentration of the mineralizer. While phase pure system was prepared with low mineralizer concentrations, with increasing mineralizer content the secondary phases were formed. Raman spectroscopy and XPS analysis were used to investigate the cation substitution and to help describe the cations bonding in co-doped calcium aluminate system. Prepared powders have been hydrated in a controlled manner at different temperatures (288, 298, 308 K). The resulting calorimetric data have been used to investigate the hydration kinetics and determine the rate constant of hydration reaction. First-order reaction (FOR) model was here applied for the activation energy and frequency factor calculations. The metastable and stable calcium aluminate hydrates were formed according to initial phase composition. In phase pure systems with low S content, the formation of stable and metastable hydrates was depended on the reaction temperature. Conversely, in systems with secondary phases and higher S content, the hydration mechanism resembled that which appears in calcium sulfoaluminates.

Investigation of the AFm-Cl system: Fe-to-Al solid solution, thermal behavior and carbonation

Iron in carbonate containing AFm phases

Chloride binding behaviors and early age hydration of tricalcium aluminate in chloride-containing solutions

Thermochemical data and phase equilibria of halide (Cl−, Br−, I−) containing AFm and hydrotalcite compounds

Factors Influencing The Stability Of Afm And Aft In The Ca-Al-S-O-H System At 25 Degrees C

Evaluation on effect of carbonation on chloride binding capacity and stability of cement hydration products with multiple testing methods

Influences of Citric Acid on the Metastability of Α-Calcium Sulfate Hemihydrate in CaCl2 Solution

Effect Of Potassium Sodium Tartrate And Sodium Citrate On The Preparation Of Alpha-Calcium Sulfate Hemihydrate From Flue Gas Desulfurization Gypsum In A Concentrated Electrolyte Solution

Chloride transport resistance of alkali-activated concrete exposed to combined chloride, sulfate and carbonation environment

Trace NaCl and Na2EDTA Mediated Synthesis of Α-Calcium Sulfate Hemihydrate in Glycerol–Water Solution

Design and characterization of iron–calcium–aluminium–silicate–hydrate as low-temperature binder

Molecular dynamics simulations of ion migration and adsorption on the surfaces of AFm hydrates

Experimental Phase Equilibria Studies in the FeO-Fe2O3-CaO-Al2O3 System in Air

Stability of hydrotalcite (Mg-Al layered double hydroxide) in presence of different anions

Hydration kinetics of C3A: effect of lithium, copper and sulfur-based mineralizers

Study on the chloride ion binding rate of sulfoaluminate cement mortars containing different mineral admixtures

Synthesis and Characterization of Calcium Sulfoaluminate Hydrates—Ettringite (AFt) and Monosulfate (AFm)

Conversion of [math] and Its Utilization in the Preparation of Cement-Slag-[math] Ternary Blends

Solid solutions amongst cement AFm phases containing nitrate and nitrite ions

Hydration in diluted solutions of brownmillerite extracted from SR cement and synthetic brownmillerite

Early Hydration and Viscoelastic Properties of Tricalcium Aluminate Pastes Influenced by Soluble Sodium Salts