Abstract:The borehole thermal resistance and internal thermal resistance are both the significant design factors for the ground heat exchanger (GHE). Careful design procedures are required for these two values to decrease GHE's length and initial cost. In this study, the effects of eight parameters (flow rate, pipe size, borehole diameter, pipe-pipe distance, layered soil, grout thermal conductivity, pipe thermal conductivity, and borehole depth) on the value of borehole thermal resistance and internal thermal resistance are investigated. In order to implement the analysis, L-32 orthogonal array has been established. An improved 3D numerical model with the four-resistance model is applied to calculate corresponding thermal resistances in all cases. Furthermore, the Taguchi method is carried out to obtain the optimal scenarios of parameters combination. Results using the optimal parameters set reveal 67.64% increase in the borehole thermal resistance and 148.29% decrease in the internal thermal resistance. The heat transfer performance can be enhanced by 9.63% at least, up to a maximum of 77.07%. The analysis of variance (ANOVA) technique is carried out lastly to figure out the relative importance of tested parameters. The results indicate that the pipe-pipe distance has the most significant impact on the borehole thermal resistance, whereas the flow rate and layered soil almost play no role in it. The pipe size and flow rate are important driving parameters in determining the internal thermal resistance while the layered soil and borehole diameter's impact can be nearly neglected.

Optimizing the Temperature of Hot outlet Air of Vortex Tube using Taguchi Method.

Statistical Assessment of Counter-Flow Vortex Tube Performance for Different Nozzle Numbers, Cold Mass Fractions, and Inlet Pressures Via Taguchi Method

Experimental Study Of The Energy Separation In A Vortex Tube

The Experimental Study on Different Ratios of Vortex Tube Hot End Pressure and Cold End Pressure

Numerical analysis for the thermal performance and flow separation in the vortex tube with different design of flow control valve

Optimization of counter flow Ranque–Hilsch vortex tube performance using Taguchi method

Experimental investigation on cooling performance of vortex tube with rectifier using Taguchi method

Numerical analysis and an approach for optimization of the Ranque–Hilsch vortex tube for a compressible flow

Simulation and Experimental Analysis of Vortex Tube Using Steel Material

Experimental, computational and optimization studies of temperature separation and flow physics of vortex tube: A review

Parameters Optimization of Fin-and-Tube Heat Exchanger with a Novel Vortex Generator Fin by Taguchi Method

Numerical Study of the Energy Separation in the Novel-Designed Vortex Tube

Optimization of heat exchangers with vortex-generator fin by Taguchi method

Optimizing thermal performance of nanofluid impinging upon a nonlinearly stretching sheet using Taguchi technique

Parameter Optimization and Experimental Study on Effect of Rounding Off Edge Radius on Heat and Mass Transfer Between Gas Layers and Thermal Performance of Vortex Tube

Numerical Analysis and Parametric Optimization on Flow and Heat Transfer of a Microchannel with Longitudinal Vortex Generators

Optimization of Vortex Tube Design and Performance for Cooling Milling Process

Computational and statistical analysis on the U‐tube heat exchanger with different passes configuration: Taguchi method

Parameters Optimization of Borehole and Internal Thermal Resistance for Single U-tube Ground Heat Exchangers Using Taguchi Method

Performance analysis of vortex tube refrigeration system by experimental method

Experimental investigation of the performance of a Ranque–Hilsch vortex tube with regard to a plug located at the hot outlet