Abstract:Other than pursuing high heat flux, pressure drop also plays a key role in microtube applications as the power and efficiency of a pump are determined in terms of pressure drop. In the literature, only a few studies focus on how tube geometry influences pressure drop. This study numerically investigates the geometry effect on microtube flow boiling and pressure drop using the volume of fluid (VOF) method. Three types of geometries are used in this study: divergent, normal, and convergent microtubes with different lengths and hydraulic diameter ratios. The transient developments of vapor formation, heat flux, and pressure drops are presented within 200 ms. It is shown that the total pressure drop in the divergent microtube is the lowest. The heat flux is decreased as the massive vapor bubbles clog the tube. However, the shortened divergent microtube can increase the heat flux up to 38713.1 W/m2 and reduce the pressure drop down to 214.24 Pa, compared to the normal one under certain flow conditions, while the tube-clogging effect is not dominant. A larger inflow mass flux can delay the vapor bubble formation on the heated wall, which is beneficial to prevent the tube clogging and leads to a higher heat flux. On the other hand, higher heat flux can be achieved in the convergent microtube due to the increasing velocity inside the tube, although it induces the highest total pressure drop. This study provides a better fundamental understanding of the microtube geometry effect on flow boiling and relevant physical insight for the future design of microscale heat transfer applications.

The Experimental Study on Different Ratios of Vortex Tube Hot End Pressure and Cold End Pressure

Experimental Study Of The Energy Separation In A Vortex Tube

Experimental Study of the Impacts of Cold Mass Fraction on Internal Parameters of a Vortex Tube

Experimental study on temperature distribution based on energy separation performance of vortex tube

Experimental Study on the Influence of Inlet Pressure on the Flow Parameters at the Reverse Flow Boundary of Vortex Tube and Its Relation with Energy Separation Performance

Numerical Analysis of Hot Ends Length Effect on the Performance of Energy Separation in Vortex Tube

The influence of working gas characteristics on energy separation of vortex tube

Numerical Studies on Thermo-Hydraulic Characteristics of Laminar Flow in a Heat Exchanger Tube Fitted with Vortex Rods

Parameter Optimization and Experimental Study on Effect of Rounding Off Edge Radius on Heat and Mass Transfer Between Gas Layers and Thermal Performance of Vortex Tube

Modification and experimental research on vortex tube

Simulation and Experimental Analysis of Vortex Tube Using Steel Material

Experimental Investigation on Flow Condensation Heat Transfer and Pressure Drop of Nitrogen in Horizontal Tubes

A numerical study of microtube geometry effect on flow boiling using the volume of fluid method

Experimental and Simulation Investigation on Heat Transfer Characteristics of Supercritical Nitrogen in a New Rib Tube of Open Rack Vaporizer

Experimental investigation of the flow characteristics within a vortex tube with different configurations

Experimental investigation on cooling performance of vortex tube with rectifier using Taguchi method

Research Of Vortex Tube Energy Separation

An experimental investigation on the effects of the vortex tube material, swirl generator material and the tube length to diameter ratio on vortex tube performance

Effect of Tube Length on the Performance of Cooling Necklace with Vortex Tube Cold Flow Generator

Single-phase pressure drop and heat transfer characteristics of turbulent liquid nitrogen flow in micro-tubes

Quantitative Analysis of Energy Transfer and Separation in Vortex Tubes: Factors and Empirical Insights