Abstract:A discrete element method (DEM) model is developed to simulate the dynamics of wet, flexible fibers. The angles of repose of dry and wet fibers are simulated, and the simulation results are in good agreement with experimental results, validating the wet, flexible fiber model. To study wet fiber flow behavior, the model is used to simulate shear flows of wet fibers in a periodic domain under Lees-Edwards boundary conditions. Significant agglomeration is observed in dilute shear flows of wet fibers. The size of the largest agglomerate in the flow is found to depend on a Bond number, which is proportional to liquid surface tension and inversely proportional to the square of the shear strain rate. This Bond number reflects the relative importance of the liquid-bridge force to the particle's inertial force, with a larger Bond number leading to a larger agglomerate. As the fiber aspect ratio (AR) increases, the size of the largest agglomerate increases, while the coordination number in the largest agglomerate initially decreases and then increases when the AR is greater than four. A larger agglomerate with a larger coordination number is more likely to form for more flexible fibers with a smaller bond elastic modulus due to better connectivity between the more flexible fibers. Liquid viscous force resists pulling of liquid bridges and separation of contacting fibers, and therefore it facilitates larger agglomerate formation. The effect of liquid viscous force is more significant at larger shear strain rates. The solid-phase shear stress is increased due to the presence of liquid bridges in moderately dense flows. As the solid volume fraction increases, the effect of fiber-fiber friction coefficient increases sharply. When the solid volume fraction approaches the maximum packing density, the fiber-fiber friction coefficient can be a more dominant factor than the liquid bridge force in determining the solid-phase shear stress.

Experimental research on free settling properties of different types of single fiber particle in air

Experimental research on the settling property of slender fiber particles under the influence of multiple factors

Research on the Interaction of Three Contact Fibers in the Fiber Suspensions

Research on the Motion of Particles in the Turbulent Pipe Flow of Fiber Suspensions

Investigation of the interactions between two contact fibers in the fiber suspensions

Fiber Orientation Distribution and Rheological Properties of Fiber Suspension in a Turbulent Jet

Experimental Research on the Hydrodynamic Instability of Fiber Suspensions in Channel Flow

A Numerical Study on Gas-Fluidized Beds of Wet Flexible Fibers

NUMERICAL RESEARCH ON THE EFFECT OF FIBERS ON THE PROPERTY OF TURBULENT FIBER SUSPENSION IN A CHANNEL

Research on the fiber orientation distribution and rhelogical property in the fiber suspensions

Orientation Distribution of Fibers and Rheological Property in Fiber Suspensions Flowing in a Turbulent Boundary Layer

A Numerical Investigation on Segregation in Gas-Fluidized Beds of Short, Flexible Fibers

Numerical simulation of fiber orientation distribution in round turbulent jet of fiber suspension

Orientational Distribution of Fibres in Sheared Fibre Suspensions

Numerical Research on the Orientation Distribution of Fibers Immersed in Laminar and Turbulent Pipe Flows

Structure and Properties of Concentrated Fiber Suspensions in A Shear Flow

Discrete element method-computational fluid dynamics analyses of flexible fibre fluidization

Discrete element simulation studies of angles of repose and shear flow of wet, flexible fibers.

Numerical simulation on velocities of two interacting fibers in fiber suspension

Hindered Settling of Fiber Particles in Viscous Fluids

Retention amount and flow behavior of droplets on cross‐fiber intersections during coalescence separation