Composition optimization of Al-Ni-Ti alloys based on glass-forming ability and preparation of amorphous coating with good wear resistance by plasma spray

Zhidan Zhou,Zhibin Zhang,Yongxiong Chen,Xiubing Liang,Baolong Shen

DOI: https://doi.org/10.1016/j.surfcoat.2020.126800

IF: 4.865

2021-02-01

Surface and Coatings Technology

Abstract:<p>Al-based alloys with compositions of Al_100-x-yNi_xTi_y (x = 5, 10, 15; y = 3, 6, 9) and Al_100-x-yNi_xTi_y (x = 10; y = 12, 15) were prepared by single-roller melt-spinning. To overcome the inability to measure the glass transition temperature, the amorphous content calculated from the X-ray diffraction pattern was used to evaluate glass-forming ability. The optimized composition with the highest glass-forming ability was Al₈₁Ni₁₀Ti₉. The microhardness of the Al₈₁Ni₁₀Ti₉ ribbons increased first and then decreased when the ribbons were annealed at temperatures from 150 to 550 °C. Precipitation of α-Al nanocrystals improved the microhardness. There was no amorphous phase in the powders based on the optimized composition prepared by the atomization method, while the amorphous content of the coating obtained by plasma spray reached up to 49.76%. This was because the cooling rate in the spray process was at least two orders of magnitude higher than that in the gas atomization process. The coating had good wear resistance and the wear mechanisms were also analyzed.</p>

physics, applied,materials science, coatings & films