Abstract:The micro- and macroscopic fatigue crack growth (FCG) rates of a wide class of structural materials were analyzed and it was concluded that both rates coincide either during high-temperature tests or at high stress intensity factor (SIF) values. Their coincidence requires a high level of cyclic deformation of the metal along the entire crack front as a necessary condition for the formation of fatigue striations (FS). Based on the analysis of digital fractographic images of the fatigue fracture surfaces, a method for the quantitative assessment of the spacing of FS has been developed. The method includes the detection of FS by binarization of the image based on the principle of local minima, rotation of the highlighted fragments of the image using the Hough transform, and the calculation of the distances between continuous lines. The method was tested on 34KhN3M steel in the initial state and after long-term operation (~3 × 105 h) in the rotor disk of a steam turbine at a thermal power plant (TPP). Good agreement was confirmed between FCG rates (both macro and microscopic, determined manually or using digital imaging techniques) at high SIF ranges and their noticeable discrepancy at low SIF ranges. Possible reasons for the discrepancy between the micro- and macroscopic FCG rates at low values of the SIF are analyzed. It has also been noted that FS is easier to detect on the fracture surface of degraded steel. Hydrogen embrittlement of steel during operation promotes secondary cracking along the FS, making them easier to detect and quantify. It is shown that the invariable value of the microscopic FCG rate at a low SIF range in the operated steel is lower than observable for the steel in the initial state. Secondary cracking of the operated steel may have contributed to the formation of a typical FS pattern along the entire crack front at a lower FCG rate than in unoperated steel.

Development of an Energy-Based Experimental Method for Estimation of Fatigue Crack Evolution in Titanium Alloys

Fatigue Crack Propagation Analysis in an Aero-Engine Turbine Disc Using Computational Methods and Spin Test

Fatigue cracking behavior and life assessment of TC11 titanium alloy in very high cycle regime at two working temperatures

METHOD OF ESTIMATING PLASTIC DEFORMATION DISTRIBUTIONS AT THE FATIGUE CRACK TIP BASED ON THE SOLUTION OF LINEAR ELASTICITY THEORY

Microstructure based cracking behavior and life assessment of titanium alloy under very-high-cycle fatigue with elevated temperatures

Computational Monitoring of an Initial Fatigue Crack Incubation and Growth in a Smooth Specimen

Estimation of Fatigue Crack Growth Rate in Heat-Resistant Steel by Processing of Digital Images of Fracture Surfaces

Determination of Fatigue Crack Growth Threshold of TC4 Titanium Alloy by In-situ Observation Technology

Study on Fatigue Crack Growth of Electron Beam Selective Melting of Titanium Alloy

A fatigue life prediction approach for porosity defect-induced failures in directed energy deposited Ti-6Al-4V considering crack growth environment

Identifying fatigue crack initiation through analytical calculation of temporal compliance calibrated with Computed Tomography

Statistical Analysis Methods of Fatigue Crack Growth Rate

Thermodynamic Investigation with Synergetic Method on Inner Crack Growth Behavior at Very High Cycle Fatigue Regime

Isothermal and thermo-mechanical fatigue-crack-growth analysis of XH73M nickel alloy

Application of a New, Energy-Based ΔS* Crack Driving Force for Fatigue Crack Growth Rate Description

Cold creep of titanium: Analysis of stress relaxation using synchrotron diffraction and crystal plasticity simulations

High cycle thermal fatigue of two austenitic stainless steels

Numerical Evaluation of Fatigue Crack Growth of Structural Steels Using Energy Release Rate with VCCT

Investigation on Fatigue Threshold Testing Methods in a Near Lamellar TiAl Alloy

Molecular dynamics simulation of effects of loading parameters on fatigue crack growth behavior in titanium single crystal

A diffusion-based approach for modelling crack tip behaviour under fatigue-oxidation conditions