Abstract:The main purpose of this study is to determine, via a three dimensions Finite Element analysis (FE), the stress and strain fields at the inner surface of a tubular specimen submitted to thermo-mechanical fatigue. To investigate the surface finish effect on fatigue behaviour at this inner surface, mechanical tests were carried out on real size tubular specimens under various thermal loadings. X ray measurements, Transmission Electron Microscopy observations and micro-hardness tests performed at and under the inner surface of the specimen before testing, revealed residual internal stresses and a large dislocation microstructure gradient in correlation with hardening gradients due to machining. A memory effect, bound to the pre-hardening gradient, was introduced into an elasto-visco-plastic model in order to determine the stress and strain fields at the inner surface. The temperature evolution on the inner surface of the tubular specimen was first computed via a thermo-elastic model and then used for our thermo-mechanical simulations. Identification of the thermo-mechanical model parameters was based on the experimental stabilized cyclic tension-compression tests performed at 20^{\circ}C and 300^{\circ}C. A good agreement was obtained between numerical stabilized traction-compression cycle curves (with and without pre-straining) and experimental ones. This 3 dimensional simulation gave access to the evolution of the axial and tangential internal stresses and local strains during the tests. Numerical results showed: a decreasing of the tangential stress and stabilization after 40 cycles, whereas the axial stress showed weaker decreasing with the number of cycles. The results also pointed out a ratcheting and a slightly non proportional loading at the inner surface. The computed mean stress and strain values of the stabilized cycle being far from the initial ones, they could be used to get the safety margins of standard design related to fatigue, as well as to get accurate loading conditions needed for the use of more advanced fatigue analysis and criteria.

High cycle thermal fatigue of two austenitic stainless steels

The low-cycle fatigue, deformation and final fracture behaviour of an austenitic stainless steel

Effects of pressurized water reactor environment and cyclic loading parameters on the low cycle fatigue behavior of 304L stainless steel

LOW CYCLE FATIGUE FRACTURE FOR 316ti STAINLESS STEEL IN HIGH TEMPERATURE AND PRESSURE WATER

Investigation on low cycle fatigue of nickel‐based single crystal turbine blade in different regions

Investigation on High Temperature Fatigue-Oxidation Behavior of Ni-based Single Crystal with Film Cooling Holes Considering Arrangement Effect

Fatigue life evaluation of metastable austenitic stainless steel AISI 347 based on nondestructive testing methods for different environmental conditions

Cyclic Stress-Strain Response During Isothermal and Thermomechanical Fatigue

Fatigue cracking behavior and life assessment of TC11 titanium alloy in very high cycle regime at two working temperatures

Thermal-Mechanical Fatigue Lifetime Prediction of an Austenitic Stainless-Steel

Effect of high temperature on crack initiation of super austenitic stainless steel 654SMO in very high cycle fatigue

Couple effects of temperature and fatigue, creep-fatigue interaction and thermo-mechanical loading conditions on crack growth rate of nickel-based alloy

Thermo-mechanical FE model with memory effect for 304L austenitic stainless steel presenting microstructure gradient

Crack Initiation Mechanisms for Low Cycle Fatigue of Type 316ti Stainless Steel in High Temperature Water

Thermodynamic Investigation with Synergetic Method on Inner Crack Growth Behavior at Very High Cycle Fatigue Regime

An Analytical Study on Cracking Directions and Damage in Thermal Fatigue Crazing Subjected to Variable Amplitude Loadings

Microcrack Initiation In Low-Cycle Fatigue Of An Austenitic Stainless Steel

Review of Creep-Thermomechanical Fatigue Behavior of Austenitic Stainless Steel

High Cycle Fatigue Of Ti-6al-4v Alloy In Simulated Steam Environment

Isothermal and thermo-mechanical fatigue-crack-growth analysis of XH73M nickel alloy

Experimental and Numerical Investigation of High-Temperature Multi-Axial Fatigue