Abstract:The paper investigated the effect of selected processing conditions during gear grinding on the value and distribution of microhardness and residual stress formed in the technological surface layer of gears after thermochemical treatment (TCT) conducted by a continuous single-piece flow method.The gears were carburised with LPC at 920C, then quenched in a 4D Quenching chamber at 7 bar and tempered at 190C for 3 hours. In the next step, the working surfaces of the gear teeth were ground by supplying grinding fluid (GF) to the grinding zone using the WET method and the MQL method with a minimum amount. Measurements were made on the distribution of microhardness and residual stress formed in the technological surface layer of gears after thermochemical treatment and after the grinding process.The results of the study showed the influence of workpiece speed vw and the method of delivery to the grinding zone GF on selected parameters describing the condition of the technological surface layer of the teeth of gears made of 20MnCr5 steel. The grinding process with a white aluminium oxide grinding wheel causes deterioration in the material's residual stress state. For each of the three analysed workpiece speeds vw, smaller changes in microhardness with respect to the microhardness of the material before grinding occur in the surface layer of samples ground with GF fed with the MQL method. Similarly, residual stress values are in the area of favourable compressive stresses.Environmental considerations and the need to comply with increasingly stringent environmental protection and worker safety regulations are pushing researchers and entrepreneurs to completely eliminate or reduce the consumption of grinding fluids in the grinding process. Based on the research and analysis carried out in this study, it was concluded that applying minimum GF by the MQL method could be an alternative to the conventional WET method.In sustainable manufacturing, it is extremely important to produce high-quality items while reducing the cost of manufacturing and taking care of the environment and workers' health. This includes the manufacture of gears, a basic component used in gear transmissions in the automotive industry, for example. The research has established that it is possible to use the MQL method, which reduces the amount of GF used when grinding the working surfaces of gear teeth, as an alternative to the conventional WET method.The conducted research was the first to determine the most favourable conditions, in terms of the obtained residual stresses and microhardness, for grinding the working surface of gear teeth using the MQL method.

Current Status of Peel Grinding Technology

Process limits in high-performance peel grinding of hardened steel components with coarse CBN grinding wheels

Theoretical Generalization and Research on the Mechanism of the Unsteady-State Grinding Technique

High performance peel grinding of steel shafts using coarse electroplated CBN grinding wheels

Towards Sustainable Grinding of Difficult-to-Cut Alloys—A Holistic Review and Trends

Advanced polishing, grinding and finishing processes for various manufacturing applications: a review

Mirror Surface Grinding by Metal Bonded Super-abrasive Wheel with Electrolytic In-process Dressing

Development of discontinuous grinding wheel with multi-porous grooves

New development and current state for high speed and super-high speed abrasive machining

Advanced Electric Discharge Machining of Stainless Steels: Assessment of the State of the Art, Gaps and Future Prospect

Stability and dynamics of parallel plunge grinding

Current Status of Hard Turning in Manufacturing: Aspects of Cooling Strategy and Sustainability

Grinding Equipment and Processes

Nanostructured grinding wheels for ultra-precision engineering applications

Effect of grinding conditions of gears made of 20MnCr5 steel after single-piece flow heat treatment on the condition of the surface layer of the tooth working surface

The Method of the Combined Flat Peripheral Grinding

Grindability studies of thermomechanically processed advanced high strength steel using sol-gel and fused alumina grain-based grinding wheels

High-speed grinding: from mechanism to machine tool

Cooling and lubrication techniques in grinding: A state-of-the-art review, applications, and sustainability assessment

Friction Stir Processing on the Tribological, Corrosion, and Erosion Properties of Steel: A Review

Application of sustainable techniques in grinding process for enhanced machinability: a review