Abstract:Vanadium oxynitride (VN x O y , x+y=1) is a metallic compound between vanadium oxides (VO, V 2 O 3 , V 2 O 5 ) and vanadium nitride (VN) which would have interesting properties and functions that potentially can be supplied for different applications. In this study, vanadium nitride and oxynitride thin films were obtained by reactive magnetron sputtering using vanadium targets, Ar as plasma carrier, and a mix of N 2 and O 2 as reactive gas. The ratio of mass flow between the two gases is maintained around O 2 :N 2 =1:20 during the process. To obtain crystalline phases of oxynitrides a post rapid thermal annealing (RTP) in Ar atmosphere at 600oC and 700oC for 5 minutes was done. The purpose of the study is to define the effect of the magnetron sputtering parameters, such as reactive gas flow rates, and annealing temperature on the composition, microstructure, and optical properties of the obtained vanadium oxynitride thin films. The characterization of obtained films includes the examination of thickness and morphology by the surface profiler and SEM; identifying crystal structures and further microstructural vibration modes of molecular polarizability by X-ray diffraction and Raman spectroscopy, respectively; evaluation of the chemical composition of films by XPS analysis; assessing of optical transmittance, reflectance, and absorbance by the UV-visible- NIR spectrometer. Experimental data reveal that the annealed films can be oxynitrides when the oxygen flow rate is below 0.25 sccm and the ratio of oxygen/nitrogen ≤1/20. The annealed vanadium oxynitride films in terms of their properties are closer to vanadium nitrides than to oxides: more metallic than semi-conductive with dark appurtenance and high optical absorbance across the spectrum between 200 and 900 nm. The optical absorbance reaches almost 90% around 300 nm and then slowly reduces to 70% at 900 nm. Thus, these films could be good optical shields. For practical usage, the deposition of O 2 :N 2 =1/20, O 2 <0.25 sccm, and 600oC annealing are recommended because of the truly low transmittance (<10%) through films.

Vanadium oxide thin films and fibers obtained by acetylacetonate sol-gel method

Vanadium Dioxide Thin Films Synthesized Using Low Thermal Budget Atmospheric Oxidation

Optical and electrical properties of vanadium oxides synthesized from alkoxides

(Digital Presentation) Fabrication and Characterization for Vanadium Oxynitride Thin Films By Magnetron Sputtering

Low Temperature Synthesis of Vanadium Pentoxide Nanocrystallines by Sol-Gel Method

Nanomechanical properties of polycrystalline vanadium oxide thin films of different phase composition

Electrical and optical properties of hydrated amorphous vanadium oxide

Properties in Vanadium Dioxide Thin Film Synthesized from V2o5 Annealed in H-2/Ar Ambience

Preparation and Thermochromic Properties of Sol-Gel-derived Zr-doped VO 2 Films

STUDY OF THE ELECTRICAL PROPERTIES OF SOL-GEL-DERIVED TITANIUM-VANADIUM OXIDE FILMS

Fabrication and Electrical Properties of Vanadium Pentoxide Fibres

Effect of vanadium precursor on dip-coated vanadium oxide thin films

Thermal transition behaviors of vanadium pentoxide film during post-deposition annealing

High Infrared Reflectance Modulation in VO2 Films Synthesized on Glass and ITO coated Glass substrates using Atmospheric Oxidation of Vanadium

Growth of ultra thin vanadium dioxide thin films using magnetron sputtering

Enhanced Post Deposition Annealing Conditions on the Fabrication of High Quality Thermochromic Vanadium Dioxide Films

Facile Fabrication of Composite Vanadium Oxide Thin Films with Enhanced Thermochromic Properties

Mesoporous carbon-vanadium oxide films by resol-assisted, triblock copolymer-templated cooperative self-assembly

Effect of Vanadium Thickness and Deposition Temperature on VO2 Synthesis using Atmospheric Pressure Thermal Oxidation

One-pot Hydrothermal Synthesis of Vanadium Dioxide Nanoparticles

Rapid laser-induced low temperature crystallization of thermochromic VO2 sol-gel thin films