Abstract:Background When conducting experiments at a synchrotron radiation facility, it is necessary to scan the position of the sample or the beam energy within a certain range. The scanning modes are categorized as step scanning and on-the-fly. In the step-scanning mode, there is a significant amount of dead time in the motion mechanism, which leads to long data acquisition times and low experimental efficiency. By contrast, the on-the-fly mode allows for continuous motion while triggering the detectors and sensors, avoiding the dead time of the motion mechanism and greatly improving the efficiency of the experiments. Purpose This study aims to propose and implement a hardware-triggered on-the-fly system to achieve rapid and continuous scanning during experimental processes for Hefei light source (HLS). Methods The proposed on-the-fly system mainly consisted of a synchronous signal acquisition module, a synchronous motion control module, and a software control module. The design of the hardware synchronous trigger module in the synchronous signal acquisition module was based on the field-programmable gate array (FPGA) development board Zynq7020. The encoder signals were decoded into position signals and used to trigger other devices based on position or time. This made it the central component for the on-the-fly mode. The design of the synchronous motion control module was based on a highly synchronous EtherCAT bus. The motion controller supported multi-axis coordination and programmable trajectory motion to meet the requirements of different experiments. The software control module utilized the experimental physics and industrial control system (EPICS) architecture for device control, and experiment flow control and data acquisition were implemented using Bluesky platform. Finally, the proposed on-the-fly system has been deployed and tested at the Soft X-ray Magnetic Circular Dichroism (XMCD) experimental station of HLS. Results The experimental results demonstrate that the on-the-fly mode system not only meets the spectral performance requirements, but also reduces the single acquisition time from tens of minutes in the step-scanning mode to approximately 1 min. Conclusions Therefore, the on-the-fly system designed and implemented in this study significantly improves the experimental efficiency and user experience.

The advanced motion control system in HEPS beamline

Design of Motion Control System Based on EtherCAT

The Control System of HLS

Better automation of beamline control at HEPS

EPICS-based Control System and Data Acquisition System of Small Angle X-ray Scattering Beamline

Development of On-the-fly Mode Control System for Hefei Light Source

The Status of Hls Control System

Design and Implementation of Control System for CYCIAE-100 Cyclotron Beam Line of Proton Radiography

Vacuum Control System for HLS

EPICS Based HLS Control System

THE CONTROL SYSTEM DEDICATED FOR BEAM LINE OF PROTON RADIOGRAPHY TEST-STAND ON A 100 MeV CYCLOTRON CYCIAE-100 *

The new control system of HLS linac and transport line

The control system of the multi-strip ionization chamber for the HIMM

New RF Control System for HLS Storage Ring

EPICS Based Computer Control System for ERL Accelerator

Mamba: a systematic software solution for beamline experiments at HEPS

Data acquisition and control system design for PET cyclotron and negative hydrogen ion source

Control System of HLS Transport Line and Linac Focusing Power Supplies

Design and Tuning of a Fast Beam Energy Selection Control System for CYCIAE-230 Cyclotron Beamline

The High Level Application Architecture of the Control System for SHINE

Injection Control System of HLS Storage Ring