Abstract:In order to offer higher average brightness and more stable photon beam, top-up injection mode is scheduled for daily operation in SSRF. Several critical beam parameters, such as filling pattern, average current, beam lifetime and transfer efficiency, need to be measured precisely and reliably, and few interlock logics need to be added into machine protection system with top-up mode. Several hardware and software optimizations of beam instrumentation for this purpose will be introduced in this paper. OVERVIEW Shanghai Synchrotron Radiation Facility (SSRF) is a third generation light source, which located at Shanghai, P.R. China. Since December 2012, SSRF has operated in top-up mode for user experiments, which was a milestone of SSRF in facility performance improvements. The topup injections are made continuously at the time interval of about 10 minutes. Each injection cycle takes about 10 seconds and the bunch change uniformity of the 500 bunch train is better than 95%. For the top-up operation, several beam parameters, such as filling pattern, average current, beam lifetime and transfer efficiency, need to be measured precisely. Some extra interlock logics were added into machine protection system. This paper will introduce the details of hardware and software optimizations of beam instrumentation for the purpose above. FILLING PATTERN Bunch charge uniformity control is very important for the top-up operation. The quality mainly depends on the precision of bunch charge & filling pattern measurement. This measurement can be realized by direct sampling BPM pickup signal [1-3] or synchrotron radiation signal [4]. Due to easy configuration and good linearity button, BPM pickups and PXI waveform digitizer based solution have been adopted [5].

Ramping Control of HLS Storage Ring

RF System Adjustment in Ramping Process of HLS

Injection Control System of HLS Storage Ring

Beam Instrumentation System Optimization for Top-up Operation in SSRF

Beam instrumentation system development and commissioning in ssrf

Analysis of Some Phenomena in the Commissioning of the Storage Ring in the Phase Ⅱ Project of the HLS

Lattice design and beam lifetime study for HLS storage ring upgrade project

Lattice optimization for the HLS-Ⅱ storage ring

A Low Emittance Lattice Design For Hls Storage Ring

The HESYRL Storage Ring Vacuum System

The Operation Status of Hls (hefei Light Source)

Linear Optics Compensation of the Superconducting Wiggler in HLS

The Magnet Design for the HLS Storage Ring Upgrade Project

Event-Driven Timing System Based on Mrf Cpci Hardware for Hls-Ii

The upgrade project of Hefei Light Source (HLS)

Feasibility Study of Full-energy Injection of HLS Injection Bump System

The advanced motion control system in HEPS beamline

Closed orbit correction of hefei light source(HLS) upgrading storage ring

Study of Injection Scheme of a Pulsed Octupole Magnet for HLS Storage Ring

Beam Loading Effects and Intensity Limit in the Injection Process of Hefei Light Source

Preliminary Study of EEHG-based Superradiant Undulator Radiation at the HLS-II Storage Ring