Abstract:The cylinder gas film seal between dual-rotor reverse shafts is a new method for sealing aircraft engines that has excellent developmental prospects. We propose a novel method for determining if the sealing ring is fully fluid-lubricated using the average Reynolds equation. Considering surface roughness and centrifugal expansion, we calculated the dynamic pressure, gas film force and friction power consumption with and without inlet pressure differences for each of the four rotation modes. The gas film’s dynamic pressure effects were weakest when the dual rotors rotated in a reverse direction (Mode 3), with or without differences in inlet pressure, since solid contact is most likely to occur under counter-rotation. When the dual rotors were in counter-rotation with an inlet differential pressure of 80 kPa and fixed inner and outer rotor speeds (e.g., 3000 rpm), we calculated the minimum sealing ring film thickness, leakage rate, friction power consumption and gas film force. Changes in outer rotor speed greatly influenced the minimum film thickness and the sealing ring’s performance. Meanwhile, changes in the inner rotor speed had little influence on the minimum film thickness and sealing ring’s lubrication performance. When the speed difference was fixed and the sealing ring was fully fluid-lubricated, lubrication performance changes were mainly affected by changes in centrifugal expansion caused by the outer rotor speed. Given a fixed rotor speed and under dual-rotor counter-rotation, we calculated the effects of inlet differential pressure changes on minimum gas film thickness, leakage rate, friction power consumption, gas film force and other sealing performance variables. Leakage rate and the friction power consumption increase as inlet differential pressure increases. Our results provide a theoretical reference for avoiding solid contact of the cylinder seal between dual-rotor reverse shafts.

Sealing Performance Analysis of Cap Seal Rings in the Stirling Engine Piston Rod

Performance Analysis of the Cylinder Gas Film Seal between Dual-Rotor Reverse Shafts Considering Lubrication and Centrifugal Expansion Effects

Measurement of Oil Film Thickness for Application to Elastomeric Stirling Engine Rod Seals

Experimental Study on Dynamic Sealing Performance under High Pressure and High Speed

The Wear of Seal Fins During High-Speed Rub Between Labyrinth Seal Fins and Honeycomb Stators at Different Incursion Rates.

Investigation Into The Performance Of The Vl Seal Based On The 3d Model

Finite Element Analysis of Reciprocating Sealing Component of Radial Single-piston Pump

Piston Rod Coating Material Study of Reciprocating Sealing Experiment Based on Sterling Seal

Numerical Analysis of the Traction Effect on Reciprocating Seals in the Hydraulic Actuator

Numerical Study on Sealing Performance after Wear of Plug Valve During Opening–closing Process

Dynamic failure analysis of static seals under pressure fluctuation in an ultrahigh-pressure water piston pump

Analysis of material fault of O-ring seal in aircraft cylinder

Lubrication performance analysis of sealing structures in rodless open cylinders

Investigation of Static and Dynamic Seal Performances of a Rubber O-Ring

Study on the thermal-stress coupling simulation and surface friction of mechanical seal for water pump

Static and Dynamic Sealing Performance Analysis of Rubber D-Ring Based on FEM

Study on Friction and Wear Performance of Sliding Metal Seal Materials Under Reciprocating Motion

Design and Experiment of Magnetic Fluid Seal of Compressor Piston Rod

Research on Key Factors of Sealing Performance of Combined Sealing Ring

Analysis of Friction and Wear Properties of Friction Ring Materials for Friction Rings under Mixed Lubrication

Investigation into the Reciprocating Sealing Performance Based on an Optical Test Method