Abstract:This paper deals with the wall film dynamics of lubrication oil in the vicinity of the scavenge port of a typical aero engine bearing chamber. Based on the major driving forces influencing the film dynamics, shear forces and gravity, two film flow regimes namely co & counter-current can be identified. The film flow in the bearing chambers is influenced by several factors which results in an undeveloped film thus making a comprehensive analysis of the flow field extremely difficult. A profound knowledge of the individual factors is required before a superposition can be performed. A simple test rig was designed and built to isolate and investigate the influence of major factors affecting the wall film dynamics in a typical bearing chamber environment. For the quantitative analysis, a parameter determined from the single phase pressure drop measurements (only in gas) is introduced to effectively analyze the undeveloped multiphase flow regime. It is shown that the momentum losses occurring in the counter-current regime become considerably greater than in the co-current regime when the shearing gas flow rate is increased beyond a certain value. For high gas flow rates (high shaft speeds in engine) the losses on the counter-current side (churning losses) can be several magnitudes larger than on the co-current side (no churning losses). It is also shown that for the conditions investigated and relevant to the bearing chamber, the possibility of waveforms leading to the droplet shedding on the co-current side is very unlikely. Significant droplet shedding occurs in the counter-current regime. Based on the results obtained, the possible characteristics of the near scavenge oil film in the absence of coexisting phenomena e.g. droplet interaction, offtake disturbances etc are outlined.

Measurement of Oil Film Thickness for Application to Elastomeric Stirling Engine Rod Seals

Comparison in Measurements of Lubricating Film of the Slipper-pair in Axial Piston Pumps

Analysis on dynamic experimental system of lubrication film properties of friction pairs in axial piston pump

Experimental Analysis On Oil Film Properties Of Plane Port Pair In Axial Piston Machine

Multi-position Measurement of Oil Film Thickness Within the Slipper Bearing in Axial Piston Pumps

Development of Experiment Rig for Lubricate Film of the Slipper-pad in Axial Piston Pumps

Real-time Measurement on Lubrication Characteristic Parameters of Plane Port Pair in Axial Piston Pumps

Online monitoring of oil film thickness of journal bearing in aviation fuel gear pump

Instrumentation of a Rolling Bearing with a Thin Film Piezo Coating for Oil Film Measurement

Experimental Investigation of Lubrication Properties at High Contact Pressure

Elastohydrodynamic lubrication simulation analysis and experimental verification of different tandem reciprocating rod seal systems

Misalignment-Induced Micro-Elastohydrodynamic Lubrication in Rotary Lip Seals

Simulation and experimentation on the contact width and pressure distribution of lip seals

Friction assessment of ultralow viscosity lubricant formulations based on a validated elastohydrodynamic simulation

Measurement of oil film thickness of a connecting-rod big end bearing by using image processing technique

Thin films in hydrodynamic lubrication regime: The Osiris friction setup

An experimental and analytical investigation of the evaporation characteristics of engine oil film

Experimental Investigation of Lubrication Oil Film Dynamics in a Typical Aero-Engine Bearing Chamber Environment

Study on Stick–Slip Friction of Reciprocating O-Ring Seals Using Acoustic Emission Techniques

Friction and Temperature Reduction in a Mechanical Face Seal by a Surface Texturing: Comparison between TEHD Simulations and Experiments

The Effect of an Electric Field on the Sliding Friction of the Silicone Rubber against Selected Metals in Motor Base Oils