Abstract:The etching of high aspect ratio structures in silicon via the Bosch process is essential in modern technologies such as microelectromechanical systems (MEMS) and through‑silicon vias (TSV) fabrication. The process can be very demanding on the mask selectivity due to long etching times, and it has been shown that an Al2O3 hard mask is very suitable in this regard, as it offers significantly higher selectivity compared to the conventional SiO2 or resist masks. In this work, we employ a combination of Scanning Electron Microscopy (SEM), Spectroscopic Ellipsometry (SE) and X-Ray Photoelectron Spectroscopy (XPS) depth profiling to scrutinize the Al2O3 mask etching mechanism and therefore the origin of the extraordinary high selectivity. We demonstrate that by increasing the passivation step time, a thicker fluorocarbon polymer layer is formed on the Al2O3, and Al2O3 is then removed with a minuscule average etch rate of ~0.01 nm/min. XPS depth profiling reveals that during Deep Reactive Ion Etching (DRIE) using the Bosch process, an AlFx layer is formed between the polymer and Al2O3. As AlFx is non-volatile, it requires sputtering to be removed. If the polymer layer is thick enough to attenuate the incoming ions such that their energy is not sufficient to lead to desorption of AlFx, such as when using a longer passivation time, the mask is not eroded. By investigating the surface after different amounts of DRIE cycles, we also obtained information about the formation rate of AlFx and the changes in the Al2O3 and polymer thicknesses over the course of a DRIE process. These findings further expand the knowledge of DRIE and can help process engineers to tailor the processes accordingly.

Research on Sapphire Deep Cavity Corrosion and Mask Selection Technology

Study on Silicon Deep Wet Etching Technology for MEMS

Deep Reactive Ion Etching of Z-Cut Alpha Quartz for MEMS Resonant Devices Fabrication

Stress-Etching Using Laser Electrochemical Micromachining with Masks

Role of Oxygen in Amorphous Carbon Hard Mask Plasma Etching

Wafer level bulk titanium ICP etching using SU8 as an etching mask

Cavity Etching Evolution on the A-plane of Sapphire Crystal in Molten KOH Etchant

A New Electroplating Mask for Deep Wet Etching on Glass

Effects of mask material conductivity on lateral undercut etching in silicon nano-pillar fabrication

SF6 Optimized O2 Plasma Etching of Parylene C

A spin-on photosensitive polymeric etch protection mask for anisotropic wet etching of silicon

High Aspect Ratio Etching of Nanopores in PECVD SiC Through AAO Mask

Sapphire Selective Laser Etching Dependence on Radiation Wavelength and Etchant

Low-Roughness Plasma Etching of HgCdTe Masked with Patterned Silicon Dioxide

Electroplating Copper Mask for Glass Deep Wet Etching in MEMS Relay

Research on Silicon Wafer Surface Phase under the Ultra-thin Slicing Process and Its Etching Hindrance Behavior during Metal-Assisted Chemical Etching

Investigation and Modeling of Etching Through Silicon Carbide Vias (TSiCV) for SiC Interposer and Deep SiC Etching for Harsh Environment MEMS by DoE

Step Coverage and Dry Etching Process Improvement of Amorphous Carbon Hard Mask

SF₆ Optimized O₂ Plasma Etching of Parylene C.

Wet Scandium Etching for hard mask formation on a silicon substrate

Etch mechanism of an Al2O3 hard mask in the Bosch process