Abstract:Thermal atomic layer etching is rapidly becoming an important complementary processing technology in the manufacturing of 5 and 3 nm devices in the semiconductor industry. Critically, architectures such as 3D NAND and 3D DRAM require conformal isotropic etching to remove material such as HfO 2 in hard-to-reach locations with aspect ratios that can be greater than 50:1. To achieve repeatable device performance throughout a 3D stack, the removal rate (etch per cycle) of the etched material during an etch process needs to be controlled such that the overall etch amount is the same from top to bottom of the device stack. In this work, the reaction kinetics of reactants and byproducts during a cyclical ligand exchange-based atomic layer etching (ALE) process have been modelled. This ALE process consists of two steps: a fluorination step followed by a fluorine-to-chlorine ligand exchange-based removal step. Modeling was performed for each of those steps separately. Experimental data revealed that the fluorine dosing during the fluorination step was predominantly responsible for controlling the etch rate of the ALE process but had only a minimal impact on the etch profile inside high aspect ratio holes. The ligand exchange dosing, on the other hand, predominantly controlled the etch profile (depth loading) with equal etch rates from top-to-bottom, obtained when the step was operated close to saturation. The model predicts that the chemical reaction rate of dimethylaluminum chloride (DMAC) on a fluorinated surface during the ligand exchange step is 9.1 s −1 , about 46 times greater than the reaction rate of hydrogen fluoride (HF) on the hafnium oxide surface during the fluorination step (only 0.2 s −1 ). Furthermore, modeling results revealed that the sticking coefficient for DMAC on a hafnium fluoride surface far exceeded that of HF on a hafnium oxide surface in the conditions modelled (0.94 s −1 for DMAC vs 0.0058 s −1 for HF). With these modeling results, the different roles fluorination and ligand exchange steps have regarding the control of etch rate per cycle and profile inside high aspect ratio holes can be explained.

Framework Integrated with Flow Cell Experiments and Simulations for Understanding Etching in Chemical Conversion Treatments

Running droplet of interfacial chemical reaction flow

Synergy Between Structure Characteristics and the Solution Chemistry in a Near/Non-Equilibrium Oxidative Etching of Penta-Twinned Palladium Nanorods

Sacrificial layer etching in bubble structure

Modified Model for Sacrificial Layer Etching

Flow-restricted Etching Method on Isotropic Substrates and Its Mechanism

Kinetics and Mechanism of the Electrooxidation of Formic Acid - Spectroelectrochemical Studies in A Flow Cell

Molecular Dynamics Simulation of Silicon Dioxide Etching by Hydrogen Fluoride Using the Reactive Force Field

A Modified Model for Etching a Sacrificial Layer in Bubble Structures

Experimental Study on Evolution of Chemical Structure Defects and Secondary Contaminative Deposition during HF-Based Etching

Metal Ions' Dynamic Effect on Metal-Assisted Catalyzed Etching of Silicon in Acid Solution

A constant potential reactor framework for electrochemical reaction simulations

Development of a ReaxFF Reactive Force Field for Pt/Cl Systems with Application to Platinum Metal Etching with Chlorine and Hydrogen Chloride Gases

Optimization of Metal-Assisted Etchant Components for Fabrication of Porous Silicon

Flow Electrolyzer Mass Spectrometry with a Gas-Diffusion Electrode Design

Experimental study on HF etching of fused silica

Flux based modeling and simulation of dry etching for fabrication of silicon deep trench structures

Surface reaction modelling of thermal atomic layer etching on blanket hafnium oxide and its application on high aspect ratio structures

Study of the Relationship Between Metal-Assisted Chemical Etching and Direction of the Applied Electric Field

A Robust Flow-Through Platform for Organic Contaminant Removal

Etching Kinetics of III–V Semiconductors Coupled with Surface Passivation Investigated by Scanning Electrochemical Microscopy