Experimental Research on the Effect of Cutting Layouts of Rolling TBM Cutters and HPWJ Nozzles on Cutting Performance

Jinliang Zhang,Hongyi Xu,Qiuming Gong,Fengwei Yang,Fan Wu

DOI: https://doi.org/10.1007/s00603-024-03758-0

IF: 6.518

2024-02-07

Rock Mechanics and Rock Engineering

Abstract:Artificial fractures on the tunnel face can promote tunnel boring machine (TBM) performance in the intact rock mass with high rock strength. High-pressure water jet (HPWJ) is a feasible choice to pre-cut the kerfs on the tunnel face to assist in TBM tunnelling. To study the effects of different layouts of the TBM cutter and HPWJ on the cutting performance and the corresponding rock breakage mechanism, a series of full-scale linear rock cutting tests were conducted. The analysis included the TBM cutter force, cutter vibration, rock muck and rock-breaking specific energy. According to the results, two HPWJ-assisted cutting layouts are recommended. One is arranging the HPWJ nozzle ahead of the cutter, making the cutter cut along the kerf. The rock damage zone after the cutter penetration was rather limited since the kerf beneath the cutter prevented the formation of the pressurized crushed zone and the generation of the lateral cracks that occurred in the intact rock. The lowest cutter force and vibration were obtained with the shallow kerf depth compared with the other layouts. Creating kerfs with a depth slightly lower than the cutter penetration is suggested to vastly save energy. Another recommended layout is arranging the nozzles between all the cutter trajectories, making the cutter cut along the middle line of two kerfs. The breakage mechanism turned to the interaction between the cutter and adjacent kerfs, macro-cracks generated from the cutter tip could propagate to the bottom of kerfs on both sides. The cutter force and the magnitude of oscillations decreased with the increasing kerf depth. The largest rock-breaking volume and lowest specific energy were obtained among all the tests. The suggested kerf depth is about twice the cutter penetration, above which the specific energy would not significantly decrease. The study is helpful to the cutterhead design of the TBM assisted with HPWJ and the promotion of TBM performance.

geosciences, multidisciplinary,engineering, geological