Abstract:A plasma–catalyst hybrid system has been developed for the direct conversion of methane to C2+ hydrocarbons in dielectric barrier discharge (DBD) plasma. TiO2 presented the highest C2+ yield of 11.63% among different dielectric materials when integrated with DBD plasma, which made us concentrate on the TiO2-based catalyst. It was demonstrated that MnTi catalyst showed the best methane coupling performance of 27.29% C2+ yield with 150 V applied voltage, without additional thermal input. The catalytic performance of MnTi catalyst under various operation parameters was further carried out, and different techniques, such as X-ray diffraction, X-ray photoelectron spectroscopy, transmission electron microscopy, and H2-temperature-programmed reduction were used to explore the effect of Mn loading on methane oxidative coupling (OCM) performance. The results showed that applied voltage and flow rate had a significant effect on methane activation. The dielectric particles of TiO2 loaded with Mn not only synergistically affected the coupling reaction, but also facilitated charge deposition to generate a strong local electric field to activate methane. The synergy effects boosted the OCM performance and the C2+ yield became 1.25 times higher than that of the undoped TiO2 under identical operating conditions in plasma, which was almost impossible to occur even at 850 °C on the MnTi catalyst in the absence of plasma. Moreover, the reaction activity of the catalyst was fully recovered by plasma regeneration at 300 °C and maintained its stability in for at least 30 consecutive cyclic redox tests. This work presents a new opportunity for efficient methane conversion to produce C2+ at low temperatures by plasma assistance.

Synergistic effect of dielectric barrier discharge plasma and Mn catalyst on CO2 reforming of toluene

Enhanced Reforming of Mixed Biomass Tar Model Compounds Using a Hybrid Gliding Arc Plasma Catalytic Process

Removal of Dilute VOCs in Air by Post-Plasma Catalysis over Ag-based Composite Oxide Catalysts

Toluene Decomposition by a Two-stage Hybrid Plasma Catalyst System in Dry Air

Plasma Induced Toluene Decomposition on Alumina-Supported Mn-Based Composite Oxides Catalysts

Unlocking the Potential of Cu/Ti3C2Tx MXene Catalyst in Plasma Catalytic CO2 Hydrogenation

Experimental and kinetic modeling study of tar partial oxidative reforming by dielectric barrier discharge plasma using toluene as a model compound

Unlocking the Potential of Cu/TiCT MXene Catalyst in Plasma Catalytic CO2 Hydrogenation

Plasma-enhanced catalysis of CO 2 reforming of propane on Ni/γ-Al 2O 3 catalyst

Carbon Dioxide Reforming of Methane to Syngas by Thermal Plasma

Plasma-catalytic oxidation of toluene over MCeZrO x /TiO 2 (M = Cu, Mn, Ni and Co) catalysts using a dielectric barrier discharge reactor

Plasma-Enhanced Chemical Looping Oxidative Coupling of Methane through Synergy between Metal-Loaded Dielectric Particles and Non-Thermal Plasma

Unlocking the Potential of Cu/Ti 3 C 2 T X MXene Catalyst in Plasma Catalytic CO 2 Hydrogenation

Experimental study on dry reforming of methane by a plasma catalytic hybrid system

Preparation and Characterization of A Plasma Treated Nimgsba-15 Catalyst for Methane Reforming with Co2 to Produce Syngas

Plasma reforming of tar model compound in a rotating gliding arc reactor: Understanding the effects of CO<sub>2</sub> and H<sub>2</sub>O addition

Steam Enhanced Carbon Dioxide Reforming of Methane in DBD Plasma Reactor

Development of Ni-Co supported on SBA-15 catalysts for non-thermal plasma assisted co-conversion of CO2 and CH4: Results and lessons learnt

Disentangling metallic cobalt sites and oxygen vacancy effects in synergistic plasma-catalytic CO2/CH4 conversion into oxygenates

Steam reforming of toluene as biomass tar model compound in a gliding arc discharge reactor

Dielectric Barrier Discharge Plasma-Assisted Catalytic CO2 Hydrogenation: Synergy of Catalyst and Plasma