Abstract:In this paper, pulse-compression thermography nondestructive testing method is proposed for defect detection in carbon fiber reinforced composite in reflection mode, using halogen lamps as excitation source. It is known that care should be taken when pulse-compression algorithm is applied to data obtained using halogen lamps. This because standard commercial halogen lamps suffer from high on/off switching delay time, thus they are not well-following the time behavior of the coded waveform employed for the heating emission modulation. The hereby-proposed method, named “Referred Pulse-Compression Thermography”, relies on subtracting the step heating contribution from the recorded coded thermal sequence before applying the pulse-compression algorithm. In particular, the step heating contribution is recorded separately by mean of an additional measurement. It is shown that the proposed method is inherently immune to the halogen-lamp switching time delay as both the reference recorded step signal and the coded signal sequence are affected by the same setback value. The proposed method can effectively enhance the defect information and improving the thermal contrast between defect and non-defect areas when halogen lamps are used in combination with pulse-compression in reflection mode. The validity of the proposed method is verified by experimental results and a comparison study with step heating thermography on different composite samples, having complex shapes and embedded artificial defects at different depths.

Detection of defect-induced luminescence in epoxy-based insulation materials via phase-resolved photon counting method

Photon counting technique as a potential tool in micro‐defect detection of epoxy insulation pull rod in gas‐insulated switchgears

Photon Count Technique As a Potential Tool for Insulation Micro-Defect Detection: Principles and Primary Results

An Ultrasonic Pulse-Echo Method to Detect Internal Defects in Epoxy Composite Insulation

Ultrasonic Detection and Diagnostic Method for the Internal Defects in Epoxy Composite

Surface Defect Detection of GIS Aramid Insulation Pull Rod Via Photon Counting

Electroluminescence and Surface Trap Distribution in Polymeric Insulation

Residual Stress Inspection by Eu3+ Photoluminescence Piezo-Spectroscopy: an Application in Thermal Barrier Coatings

Screening for electrically conductive defects in thin functional films using electrochemiluminescence

Enhanced Ability of Defect Detection Using High Voltage Time-Domain Resonance Analysis and Impedance Spectrum

Unraveling the luminescence signatures of chemical defects in polyethylene

Explorative Study on a Novel Ellipsometry Detection Method for Space Charge Inside Solid Insulation: Towards High Temporal and Spatial Resolutions

Self-Reporting Microsensors Inspired by Noctiluca Scintillans for Small-Defect Positioning and Electrical-Stress Visualization in Polymers

Correction of the Relationship Between Opticalelectrical Signal and Charge Quantity in Partial Discharge Combined Detection

In Situ Self-Fluorescence 3D Imaging of Micro/Nano Damage in Silicone Gel for Understanding Insulation Failure under High-Frequency Electric Fields

Study on Ultrasonic Spectral Characteristics of Internal Defects in Epoxy Composite Materials

Electroluminescence Andsurface TrapDistribution Inpolymeric Insulation

High-sensitivity Phase Imaging Eddy Current Magneto-Optical System for Carbon Fiber Reinforced Polymers Detection

Investigation on Surface Trapping and Electroluminescence Phenomena in Polymeric Insulation Materials

Numerical Simulation Research on Partial Discharge of Particle Defects at Epoxy Interface Excited by High-Frequency Sinusoidal Voltage

Halogen Optical Referred Pulse-Compression Thermography for Defect Detection of CFRP