Abstract:An ingenious design, Traveling Wave Reactor (TWR) has been suggested for full exploitation of uranium resources in next generation of nuclear reactors. This design involves the slow propagation of a nuclear fission wave through a long initially subcritical core and the transmutation of nuclear fuel. It has been widely proven that the initiation and propagation of fission waves are feasible prompting the Terra Power Company to conduct preliminary commercialization studies on this project. In equilibrium state, the shapes of the neutron flux, nuclide densities and power density distribution remain constant but the burning region moves in axial (or radial) directions. In this case the in situ fissile material production and consumption drives the operation. Only natural or depleted uranium is required for fresh fuel region. However, in equilibrium state, the burning region contains a spectrum of fission products as well as higher actinides whose are not easily available for initial TWR core construction. One solution is based on the use of enriched uranium in the first cycle to ignite the fission wave and then employment of the composition in subsequent cycles up to the equilibrium state. The main objective of this work is the feasibility study of forming a fission wave as well as the neutronic analysis of a Gas-Cooled Traveling Wave Reactor in various cycles up to the equilibrium one. The MCNP Monte Carlo code was utilized for the analysis of criticality and burn-up calculation. In each cycle, the axial fresh fuel loading and spent fuel discharge, were subjected to analysis. Results showed that the equilibrium state can be obtained by using special arrays of absorbers, from the third cycle where the shape of neutron flux and the power density distribution in axial direction remain unchanged.

Neutronic and thermal-hydraulic analysis of fission molybdenum-99 production at Tehran Research Reactor using LEU plate targets

Developing a new target design for producing 99Mo in a MTR reactor

Shielding design and analysis of the hot cell used to produce fission molybdenum-99

Analysis of molybdenum-99 production at the WWR-K research reactor

Neutronic simulation of Traveling Wave Reactor (TWR) core in multi-cycles using Monte Carlo method

Neutron-Physical and Radiation Characteristics of Different Low Enrichment Fuels (Thorium and Uranium) in a Proposed JRTR Research Reactor

Study of the 199Au nanoparticles production parameters via irradiation of platinum target by using thermal neutrons

Recent activities of kaeri related to fission mo-99

Theoretical assessment and targeted modeling of TiO2 in reactor towards the scandium radioisotopes estimation

Calculations of neutron fluxes and isotope conversion rates in a thorium-fuelled MYRRHA reactor, using GEANT4 and MCNPX, Nuclear Engineering and Design

Dependence of neutron rate production with accelerator beam profile and energy range in an ADS-TRIGA RC1 reactor

Innovative Compact Molten Salt Reactor (ICMSR) Analysis for Mo-99 Production

Development of LEU-based targets for radiopharmaceutical manufacturing: A review

Neutronic Evaluation of LWR Based SMR with TRU Fuel and Comparison with Different Core Configuration of UO2 and MOX Fuel

Possibility assessment for production of non-traditional nuclear fuel in thorium blanket of hybrid thermonuclear reactor

Sustainable supply of 99Mo source in a 2 MW molten salt reactor using low-enriched uranium

Investigating the possibility of using a mixture of thorium with different fissile materials as a fuel in TRISO particles for the PBMR-400 reactor

Research study of possibility producing radioisotope Mo-99 in the active core of the BN-600 reactor using an irradiated assembly with a high flux of thermal and resonance neutrons

PRELIMINARY NEUTRONICS AND THERMAL-HYDRAULICS STUDY ON THORIUM BASED HTR-PM WITH OUTER BREEDING ZONE

Thermoluminescent and Monte Carlo dosimetry of a new 170Tm brachytherapy source

Preliminary Study on the Neutronics and the Heat Releasing Rate Characteristics of 99 Tc Transmutation Target