Abstract:Due to the continued increasing levels of CO2 emissions that is contributing to climate change, CO2 mitigation technologies, particularly carbon capture and storage, are being developed to address the goal of abating CO2 levels. Carbon capture technologies can be applied at the pre-combustion, oxy-fuel combustion, and post-combustion stages, the latter being the most widely used due to its flexibility. Among the several CO2 separation processes available for carbon capture, absorption is the most widely used where amine solutions are used as absorbents. This paper highlights the use of a wetted wall column fabricated by Siy and Villanueva (2012) and simulated flue gas to determine the performance of CO2 absorption in terms of the percentage of CO2 absorbed, the steady state time, and the overall gas mass transfer coefficient. The concentrations used were 1, 5, 10, and 15% NH3(aq) at a constant temperature range of 12-17oC, solvent flow rate of 100 mL/min, and simulated flue gas flow rate of 2 L/min. It was found that increasing the solvent concentration resulted in a proportional increase both in the percentage of CO2 absorbed and the overall gas mass transfer coefficient. The average percentage of CO2 absorbed ranged within 52.25% to 95.29% while the overall mass transfer coefficient ranged from 0.1843 to 0.7746 mmol/m2∙s∙kPa. However, erratic behavior was seen for the time required for the system to reach steady state. Using Design ExpertTM for analysis, the results showed that the effect of varying the concentration had a significant effect on the percentage of CO2 absorbed and the overall gas mass transfer coefficient. The results proved that the greater the aqueous ammonia concentration, the greater the percentage of CO2 absorbed. The range of 5-10% aqueous ammonia is recommended because the percentage of CO2 absorbed peaks at an average of 92% beyond the range of 5-10%.

A venturi reactor with an excellent mass transfer performance for carbon dioxide capture

Experimental Study on Carbon Dioxide Absorption by Aqueous Ammonia with Nickel and Chromium Ions in Bubbling Tower at Low Temperatures

Reducing Aerosol and Ammonia Emission in Post-Combustion CO2 Capture: Additives As Key Solutions

Kinetics and mass transfer of carbon dioxide absorption into aqueous ammonia

Volumetric Overall Mass Transfer Coefficients of CO_2 Absorption Into Aqueous Ammonia of Fine Spray

Absorption of carbon dioxide in aqueous ammonia

Mass Transfer and Kinetic Characteristics for CO2 Absorption in Microstructured Reactors Using an Aqueous Mixed Amine

Studies on absorption and regeneration for CO 2 capture by aqueous ammonia

Experimental Study on Co2 Absorption by Aqueous Ammonia Solution at Elevated Pressure to Enhance Co2 Absorption and Suppress Ammonia Vaporization

A Novel Method to Recover Ammonia Loss in Ammonia‐based CO 2 Capture System: Ammonia Regeneration by Vacuum Membrane Distillation

Optimization of Carbon Capture Process Using Aqueous Ammonia with Rate-Based Simulation Method

Mass Transfer Coefficients for CO2 Absorption into Aqueous Ammonia Solution Using a Packed Column

Intrinsic Insight of Energy-Efficiency Optimization for CO2 Capture by Amine-Based Solvent: Effect of Mass Transfer and Solvent Regeneration

Carbon Dioxide Absorption in a Fabricated Wetted-Wall Column Using Varying Concentrations of Aqueous Ammonia

Enhancement Technologies of Ammonia-Based Carbon Capture: A Review of Developments and Challenges

Experimental study on regeneration characteristic of C02-rich ammonia solution and absorption characteristics of the regenerative solution

Numerical Study on Absorption of Carbon Dioxide and Mass Transfer Performance in Hollow Fiber Membrane Contactor

Experimental Studies on Suppression of Ammonia Vaporization by Additives

Experimental Study on Regeneration Characteristic of CO2-rich Ammonia Solution and Absorption Characteristics of the Regenerative Solution

Carbon dioxide absorption by Ammonia-promoted aqueous triethanolamine solution in a packed bed

Experimental Studies on Removal Capacity of Carbon Dioxide by a Packed Reactor and a Spray Column Using Aqueous Ammonia