Abstract:Efforts to simulate the extreme toughness of the polycrystalline diamond variety known as carbonado typically entail the sintering of diamond powders in the presence of metal solvent-catalysts. In this study, we have attempted to duplicate the carbonado microstructure by sintering diamond powders without catalysts in a multi-anvil press at pressures of 6 to 9 GPa, temperatures of 1200 to 1800 degreesC, and times up to 6 h. The resultant microstructural defect assemblages for each experimental condition were characterized by transmission electron microscopy (TEM). Despite the absence of catalysts, sintered compacts were successfully produced for all runs, though intergranular porosity was significantly higher than that observed in natural carbonado. Primary grain sizes were reduced by more than 50% from their original dimensions in some experiments due to surface fracturing and abrasion, and aperiodic slip planes rigorously parallel to {111} consistently emerged in high densities, with lamellar spacings of 3 to 30 nm. In addition, sintering over all conditions produced polysynthetic spinel twinning in close association with the partial slip defects.Compacts compressed at 8 GPa produced some euhedral crystals with very low dislocation densities surrounded by grains in which dislocation densities were quite high. In addition, curviplanar defects loosely constrained to {111} were visible within some specimens sintered at the highest pressures. These textures resembled the polygonalization fabrics and defect microstructures observed in natural carbonado (De et al. 1998), and the appearance of these features suggests that our experiments at their most extreme pressure and temperature parameters reproduced carbonado-like defect assemblages. The formation of such textures in quasi-hydrostatic experiments suggests that shock metamorphism is not required to produce the periodic defect lamellae observed in carbonado.

Dielectric Properties of Synthetic Diamond Polycrystals

Synthesizing bulk polycrystalline diamond by method of direct phase transition

Electromagnetic properties of polycrystalline diamond from 35K to room temperature and microwave to terahertz frequencies

Elastic Property of SiC-Diamond Composite under Hydrostatic Pressure

Synthesis of Nano-Polycrystalline Diamond under High Pressure and High Temperature

Charge-based deep level transient spectroscopy of B-doped and undoped polycrystalline diamond films

Doping type influence on physical diamond properties

Dielectric properties of diamond using an X-band microwave split dielectric resonator

Dielectric properties of diamond/SiC composite fabricated by Si vapor infiltration process

Effect of sp2-Hybridized Carbon Inclusions in Diamond Films on the Sensor Performance Toward Synchrotron Radiation

Effect of pressure on sintering behavior of polycrystalline diamond

Microstructural Study of Synthetic Sintered Diamond and Comparison with Carbonado, A Natural Polycrystalline Diamond

Hall measurements on nitrogen-doped Ib-type synthetic single crystal diamonds at temperatures 550–1143 K

Temperature dependent dielectric characteristics of PPY/Y2O3 composite

Thermal Conductivity of Diamond Mosaic Crystals Grown by Chemical Vapor Deposition: Thermal Resistance of Junctions

Superconductivity in Polycrystalline Diamond Thin Films

High-Pressure Synthesis and Characterization of Ge-Doped Single Crystal Diamond

Effect of transition metals on the dielectric properties of diamond-like silicon-carbon films

Ab-initio dielectric response function of diamond and other relevant high pressure phases of carbon

Elastic Softening in Synthetic Diamonds

Low Temperature Thermal Properties of Nanodiamond Ceramics