Abstract:Contact engineering on monolayer layer (ML) semiconducting transition metal dichalcogenides (TMDs) is considered the most challenging problem toward using these materials as a transistor channel in future advanced technology nodes. The typically observed strong Fermi-level pinning induced in part by the reaction of the source/drain contact metal and the ML TMD frequently results in a large Schottky barrier height, which limits the electrical performance of ML TMD field-effect transistors (FETs). However, at a microscopic level, little is known about how interface defects or reaction sites impact the electrical performance of ML TMD FETs. In this work, we have performed statistically meaningful electrical measurements on at least 120 FETs combined with careful surface analysis to unveil contact resistance dependence on interface chemistry. In particular, we achieved a low contact resistance for ML MoS2 FETs with ultrahigh-vacuum (UHV, 3 × 10-11 mbar) deposited Ni contacts, ∼500 Ω·μm, which is 5 times lower than the contact resistance achieved when deposited under high-vacuum (HV, 3 × 10-6 mbar) conditions. These electrical results strongly correlate with our surface analysis observations. X-ray photoelectron spectroscopy (XPS) revealed significant bonding species between Ni and MoS2 under UHV conditions compared to that under HV. We also studied the Bi/MoS2 interface under UHV and HV deposition conditions. Different from the case of Ni, we do not observe a difference in contact resistance or interface chemistry between contacts deposited under UHV and HV. Finally, this article also explores the thermal stability and reliability of the two contact metals employed here.

Critical assessment of contact resistance and mobility in tin perovskite semiconductors

Investigation of Electrode Electrochemical Reactions in CH3NH3PbBr3 Perovskite Single‐Crystal Field‐Effect Transistors

The Importance of Contact Resistance in High-Mobility Organic Field-Effect Transistors Studied by Scanning Kelvin Probe Microscopy

The intrinsic (trap-free) transistors based on perovskite single crystals with self-passivated surfaces

Ambient−Stable 2D Dion−Jacobson Phase Tin Halide Perovskite Field−Effect Transistors with Mobility Over 1.6 Cm2 V−1 S−1

Optimizing 2D-metal contact in layered Tin-selenide via native oxide modulation

Evaluating mobility extraction reliability in non-ideal organic transistors utilizing weak epitaxy-grown pentacene films

Toward High-mobility and Low-power 2D MoS2 Field-effect Transistors

Probing photoelectrical transport in lead halide perovskites with van der Waals contacts

Analysis of Ultrahigh Apparent Mobility in Oxide Field‐Effect Transistors

Recent Progress in High-Mobility Organic Transistors: A Reality Check

A solvent-based surface cleaning and passivation technique for suppressing ionic defects in high-mobility perovskite field-effect transistors

Contact Resistance Optimization in MoS${_2}$ Field-Effect Transistors through Reverse Sputtering-Induced Structural Modifications

Field-effect transistors of high-mobility few-layer SnSe$_{2}$

Charge transport in mixed metal halide perovskite semiconductors

Low Contact Resistance on Monolayer MoS2 Field-Effect Transistors Achieved by CMOS-Compatible Metal Contacts

Recent Progress in Contact Engineering of Field-Effect Transistor Based on Two-Dimensional Materials

Accurate Field‐Effect Mobility and Threshold Voltage Estimation for Thin‐Film Transistors with Gate‐Voltage‐Dependent Mobility in Linear Region

Reliable Mobility Evaluation of Organic Field-Effect Transistors with Different Contact Metals

Long-range charge carrier mobility in metal halide perovskite thin-films and single crystals via transient photo-conductivity

High-Mobility Inse Transistors: the Role of Surface Oxides